How many types of router?
No Answer is Posted For this Question
Be the First to Post Answer
Using the access-list command, 'access-list 1 deny 2.2.2.2', what else must be done to stop host 2.2.2.2 from sending any traffic out of physical interface E0, while still allowing other traffic? A.) In global mode, Add a line - 'access-list 1 permit 0.0.0.0 255.255.255.255' B.) On interface E0, Add a line - 'access-group 1 in' C.) In global mode, Add a line - 'access-list 1 permit all' D.) On interface E0, Add a line - 'access-list 1 in' E.) On interface E0, Add a line - 'access-list 1 out' F.) On interface E0, Add a line - 'ip access-group 1'
Which two physical interfaces support PPP? (Choose two) A. Ethernet B. Token Ring C. Synchronous serial D. Asynchronous serial
What is VLSM? how to Calculate VLSM? where it is use and why?
Which of the following would be displayed by the command 'SHOW CDP NEIGHBOR DETAIL'? A.) The incoming/outgoing port. B.) The hardware platform. C.) One address per protocol. D.) Amount of Flash Memory Available E.) The routers hostname. F.) The subnet mask, if IP is configured.
Ping uses which Internet layer protocol? A.) RARP B.) ICMP C.) ARP D.) FTP
what is the need og jitu(config)#ip helper address <ip address> can any one exaplain it briefly specially shain i am looking towards you.Becoz you are the only one who can solve my that problem not even jitendera sinha
what is the difference between a passive and active hub?? which is better ??
Identify the correct pair of Novell Ethernet encapsulation and Cisco terminology? A.) Ethernet II, Snap B.) Ethernet 802.3, Novell-Ether C.) Ethernet SNAP, Arpa D.) Ethernet 802.2, Snap
How do you configure a cisco router for routing ipx?
What is the default routing metric used by IGRP? A.) MTU, delay, bandwidth, reliability, and loading B.) Count to infinity C.) Bandwidth and delay D.) Hop count
What is LSA? How many types of LSA used by OSPF version 2??
Explian what is a node?