Mention what is the matric of eigrp protocol?


No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More CCNA Interview Questions

What is cisco?

0 Answers  


Explain the types of communication in ipv4?

0 Answers  


What is the default LMI type for Cisco Routers that are using Frame-Relay? A.) Annex D B.) Q933A C.) Cisco D.) IETF E.) ARPA F.) Anex A

2 Answers  


What does the term Base refer to in 100BaseT A. cabling type B. singnal type C. 100 mode type D. spectrum used E. speed category

3 Answers  


How many Frame-relay encapsulation types are available with Cisco routers? A.) Four B.) Two C.) Five D.) Three

1 Answers   Cisco,






why we give clock rate to DCE and not to DTE what is the difference in the two.

3 Answers  


What device has content-addressable memory (CAM) and what is stored in it? 1 A: Switch, learned IP addresses 2 B: Router, learned IP addresses 3 C: Switch, learned MAC addresses 4 D: Router, learned MAC addresses

4 Answers  


All equipment located at the customers site is called: A.) CPE B.) CO C.) DCE D.) Demarc E.) DTE

1 Answers  


Why ESP Transport mode is not compatible with NAT????? Though New IP Header in Tunnel mode & Original IP Header in Transport mode are out of Authentication & Encryption.

1 Answers  


Which statement about the Committed Information Rate (CIP) is true? A. It is the rate in bits per second at which the Frame Relay switch agrees to transfer data B. It is the clock speed (pod speed) of the connection (local loop) to the Frame Relay cloud C. It is the maximum number of bits that switch can transferduring any Committed Rate Measurement Interval D. It is a signaling standard between the 3PE device and FP switch. It is responsible for managing the connection and maintaining status between the devices.

1 Answers  


You have an IP host address of 201.222.5.121 and a subnet mask of 255.255.255.248. What is the broadcast address? A. 201.222.5.127 B. 201.222.5.120 C. 201.222.5.121 D. 201.222.5.122

1 Answers  


What is a characteristic of Store and Forward switches? A.) They forward the frame before it is completely read. B.) They work at wire speed. C.) They are the same a Cut-Through switching. D.) They read the entire frame and check CRC before forwarding. E.) They decrease latency.

1 Answers  


Categories