Answer / guest

Answer: B

When setting up a frame-relay network between a Cisco router and a non-Cisco router, what encapsulation type should you use? A.) SAP B.) CISCO C.) IANA D.) Apollo E.) IETF F.) Q933A

2 Answers  

---

What is the routing metric used by RIP? A.) Route poisoning B.) Split horizon C.) Hop Count D.) TTL

1 Answers  

---

Which two statements about frame tagging are true? (Choose two) A. A filtering table is developed for each switch. B. Frame tagging assigns a unique user defined ID to each frame. C. A unique identifier is placed in the header of each frame as it is forwarded between switches. D. Frame tagging is a technique that examines particular information about each frame based on user defined offsets.

2 Answers  

---

Value in which type of access list?

0 Answers  

---

Inverse ARP serves what purpose? A.) Method for a local router to introduce itself to the remote end of the connection B.) Broadcast a routing table update C.) Identify MAC addresses if the IP address is known D.) Sent every 10 seconds used to verify the Frame Switch is still active

1 Answers  

---

How many LMI types are available on Cisco routers? A.) Four B.) Two C.) Five D.) Three

3 Answers  

---

What is LSA? How many types of LSA used by OSPF version 2??

2 Answers   Hathway, IBM,

---

Can anyone explain in details the STP port state?????

2 Answers  

---

Which two statements about the store and forward switching method are true? (Choose two) A. Latency remains constant regardless of frame size. B. Latency through the switch varies with frame length. C. The switch receives the complete frame before forwarding it. D. The switch checks the destination address as soon as it receives the header and begins forwarding the fram immediately.

1 Answers   CD,

---

hi... i am usin packet tracer 5.0.. i hav connect two routers A and B. A has 200.100.25.100 and 1.0.0.1 and router B has 200.100.50.100 and 1.0.0.2... i hav connected 1.0.0.1 and 1.0.0.2... now i want to route 200.100.25.100 and 200.10.50.100 usin rip.. i enable rip in both the routers... but whn i give the command show ip route... i jus get this Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area * - candidate default, U - per-user static route, o - ODR P - periodic downloaded static route Gateway of last resort is not set A# so can sombody tell me where i hav gone wrong... thanku

4 Answers  

---

Want to be a Cisco certified person through authorized training and certification center ?

0 Answers   Mercury Solutions,

---

Mention the conversion steps of data encapsulation?

0 Answers  

---