Which of the following are examples of the Session Layer?
A.) IP
B.) Netbios Names
C.) NFS
D.) Token Ring
E.) SQL
F.) RPC
Answers were Sorted based on User's Feedback
Classful routing protocols do not include subnet masks in their routing updates. Which of the following routing protocols are considered classful? A.) EIGRP B.) OSPF C.) TCP D.) IGRP E.) RIP F.) IP
Tell me how many hop counts are by default and how much you can increase in eigrp protocol?
Identify the 2 rules used when configuring a Distance Vector routing protocol? A.) Physically connected network(s) B.) Configure the classfull address, no subnets C.) Enable CDP so neighbors can be detected D.) Same autonomous network
Which two types of route table entries are used by a Layer 3 router to determine the appropriate path to destination? (Choose two) A. static route entry B. default route entry C. Dynamic route entry D. temporary route entry E. permanent route entry
You want a message to be displayed every time someone tries to log on to the router. Which command is required to accomplish this task? A.) motd#(message)# B.) banner motd(message) C.) banner motd#(message)# D.) banner motd*(message) E.) banner login#(message)#
A traffic light is an example of what type of mechanism? A.) Collision detection B.) Flow control C.) Sequence numbering D.) Network management
What is the regional Telco office called, where the customers local loop terminates? A.) Demarc B.) DTE C.) DCE D.) CO E.) CPE
in the ospf area network dr and bdr selection procedure occur let there are 4 router in that n/w r1 have the higher priority then r2 and r2 have higher priority then r3 and so on like that r1>r2>r3>r4 now as we know that selection of dr and bdr based upon the router priority so in this case r1 will be dr and r2 will be bdr now my question is that if i am going to implement 5th router which have greater priority then r1 then will it become dr atomically remember that i am not going change my 5 or 1st router property answer that one please
Hi, If we create more Gateway from one our Router Interface Gateway (Example: by set up a ISA server etc) will it effect on our bandwidth to be low? please help me
Mention the conversion steps of data encapsulation?
When setting up a frame-relay network between a Cisco router and a non-Cisco router, what encapsulation type should you use? A.) SAP B.) CISCO C.) IANA D.) Apollo E.) IETF F.) Q933A
Which network mask should you place on a Class C address to accommodate a user requirement for five networks with a maximum of 17 hosts on each networks A. 255.255.255.192 B. 255.255.255.224 C. 255.255.255.240 D. 255.255.255.248