What is the purpose of Split Horizon? A.) It prevents the regular update messages from reinstating a route that has gone down B.) Information received on an interface cannot be sent back out the same interface C.) Informs all neighbor routers that two routes exist D.) Tells the router the destination is unreachable

1 Answers  

---

Why we use filter option?

0 Answers  

---

Identify the 3 characteristics of IGRP? A.) Uses hop count as a metric B.) Supports multiple unequal paths C.) Administrative distance is 100 D.) Configured with an Autonomous system number E.) Link state

1 Answers  

---

In configuring a router, what command must be used if you want to delete the configuration data that is stored in the NVRAM?

0 Answers  

---

I am facing one problem in my layer 2 switch I don’t know the problem is on switch side or client side. The problem is some PC (not all) are stop participate in LAN they don’t send or recd. Packet from switch and if I check RJ45 (with LAN tester)from PC side the packet and 8 pin wire is working fine and after that process of LAN tester I plug RJ 45 in PC now PC start recd/ send packets what is the problem I don’t understand even client side no virus found RJ45 is ok and switch has no problem bcoz other PC is working fine Cable (cat 5 ) is also fine bcoz I didn’t crimp again just check in LAN tester and start working fine. Plz any one solve this matter. And after lan tester process pc is working fine and after 2 or 3 hour it again start same problem and again same process lan tester I have used

5 Answers  

---

Identify the purpose of ICMP? A.) Avoiding routing loops B.) Send error and control messages C.) Transporting routing updates D.) Collision detection

2 Answers   Hughes,

---

Identify IPX SAP and it's purpose? A.) Sonet Access Pipe - interface to Sonet ring B.) Service Advertising Protocol - advertise services C.) Server Appletalk Protocol - appletalk directory services D.) Service Access Point - identify upper layer protocols

3 Answers  

---

Is hsrp is cisco proprietary or introduced by ieee?

0 Answers  

---

What is L2 Link and its significance regarding IP addressing.

2 Answers   HCL,

---

What are 10base2, 10base5 and 10baset ethernet lans?

0 Answers  

---

When does network congestion occurs?

0 Answers  

---

You are logged into a router, what command would show you the IP addresses of routers connected to you? A. show cdp neighbors detail B. show run C. show neighbors D. show cdp

2 Answers  

---