Answer / guest

Answer: A D

PPP PAP authentication sends the username and passwords in
clear text

and the remote node initiates the authentication process.

What is true when using DDR? A.) HDLC is the preferred encapsulation B.) You must use static routing C.) You should use dynamic routing D.) You should use ISDN

1 Answers  

---

which of the following address represent unicast address A 224.1.5.2 B ffff.ffff.ffff.ffff C 192.168.24.59/30 D 255.255.255.255 E 172.138.128.255 plz tell what should be answer plz tell with explanation

5 Answers   IPsoft, jetking,

---

Suppose we are having two router i.e. Router1 and Router 2 connected with each other on Serial Link,Router Network having ip 192.168.1.0/24. 1> which ip is used at router1 and router2 interface? 2>Which Command is used to assign ip to router1 and router2 interface?

1 Answers  

---

Your Ethernet interface currently has the IP address of 1.1.1.1/24. You would like it to have a second IP address of 2.2.2.2/24. Which command will do that? A.) ip address 1.1.1.1 2.2.2.2 255.255.255.0 B.) ip address 2.2.2.2 255.255.255.0 secondary C.) ip address 2.2.2.2 255.255.255.0 D.) This cannot be done, you can only have 1 IP address per physical interface. E.) ip address 2.2.2.2 /24

1 Answers  

---

Which layer manages protocol access to the Network layer? A.) Datalink - MAC Sublayer B.) Datalink - LLC Sublayer C.) Transport D.) Session E.) Network

3 Answers  

---

Which 3 statements describe default encapsulation and LMI type configuration? A.) There are only 4 encapsulations and 3 LMI type options B.) The LMI type config term options C.) In release 11.2 the LMI type is autosensed D.) The default LMI is Cisco E.) IETF encapsulation must be configured unless the connecting routers are both Cisco

1 Answers  

---

Why OSPF uses 2 Multicast IP

2 Answers  

---

For IPX, what is the DEFAULT Cisco Encapsulation on an Ethernet interface? A.) novell-ether B.) gns C.) snap D.) arpa E.) sap F.) dix

1 Answers  

---

If line down and protocol also down; in this case which layer move problem?

0 Answers  

---

Identify the command that configures serial0 for PPP encapsulation? A.) Router(config)# encapsulation ppp B.) Router(config-if)# encapsulation serial ppp C.) Router(config-if)# encapsulation ppp D.) Router# encapsulation ppp

2 Answers  

---

How do you set the encapsulation type to PPP for an interface? A.) encap ppp B.) ppp encapsulation C.) encapsulation ppp D.) encapsulation ppp enable E.) ppp enable encapsulation

2 Answers  

---

The -- terminal no editing -- command will perform what function? A.) Edit the contents of NVRAM B.) Allows access to the terminal port C.) Stops the advanced editing feature D.) Enable password functions

2 Answers  

---