Interested to Buy Any Domain ? << Click Here >> for more details...
Identify the statement which connects access-list 101 inbound to
interface e0?
A.) Router(config-if)# ip access-group 101 in
B.) Router(config-if)# ip access-group 101
C.) Router(config)# ip access-group 101 e0 in
D.) Router(config)# ip access-group 101 e0 in
- 1 Answers
- 4342 Views
- I also Faced
- E-Mail Answers
Identify the command to reload the router? A.) Router(config)# reload B.) Router# reset C.) Router# reload D.) Router> reload
What is encapsulation and de-encapsulation?
Identify 2 HDLC characteristics? A.) Default serial encapsulation B.) Open standard C.) Supports Stacker compression D.) Supports point-to-point and multipoint
Which Cisco IOS command should you use to display the Novell IPX address assignments on a router? A. show ipx addresses B. show ipx interface C. show me the money D. ipx, network (number) E. display ipx addresses F. show ipx routing details
Which layer hides details of network dependent information from the higher layers by providing transparent data transfer? A.) Transport B.) Physical C.) Data Link D.) Session E.) Application F.) Network
Identify 3 methods not used to prevent routing loops? A.) Holddown timers B.) Sequence numbers C.) Triggered updates D.) Split horizon E.) Area hierarchies F.) Order of router startup
Explain the difference between switch & hub?
The Cisco IOS is stored in: A.) ROM B.) CD C.) Flash D.) NVRAM
Which device listed below provides clocking for the line? A.) DCE B.) CPE C.) CO D.) DTE E.) Demarc
What are the generic parts of a network layer address? A. an intenetworks number and a URL B. a vendor code and a serial number C. a network number and a host number D. a broadcast number and a unicast number E. a domain identifier and a device identifier
In distance-vector routing, there is a problem known as the 'count to infinity' problem. What is the most direct solution to this? A.) Defining a Maximum. B.) You can not solve the 'count to infinity' problem with a distance vector protocol. C.) Poison Reverse. D.) Triggered Updates. E.) Split Horizon.
How do you disable CDP on the entire Router? A.) Router#no cdp run B.) Rotuer(config-if)# no cdp enable C.) Router(config)# no cdp enable D.) Router(config)# no cdp run
CCNA 
