Answer / raghu

routing information means content of routing table
it has the best roots to reach the destinations
if there is any changes in network then dynamic protocals
like rip ,ospf,eigrp will exchange this routing information

What is the difference between bus topology and hub?

0 Answers  

---

What are the possible ways of data transmission in ccna?

0 Answers  

---

Which command will enable CHAP authentication on a serial interface that is using PPP? A.) encapsulation chap B.) ppp chap C.) ppp enable chap D.) ppp encapsulation chap E.) ppp authentication chap F.) ppp chap enable

2 Answers  

---

Utilizing RIP, what is the limit when it comes to number of hops?

0 Answers  

---

Identify the true statements about the following access list: Access-list 101 deny tcp 192.10.172.0 0.0.0.255 any eq 23 Access-list 101 permit ip any any A.) This access list prevents the host 192.10.172.0 from telneting B.) This access list prevents any telnet traffic from subnet 192.10.172.0/24 C.) This access list filters some telnet access D.) This access list denies any telnet traffic to subnet 192.10.172.0/24 E.) This access list is invalid F.) The netmask on the this access list is reversed

1 Answers  

---

Which of the following are examples of the Datalink Layer? A.) LLC B.) SQL C.) TCP D.) Token Ring E.) IP

2 Answers  

---

Switching methods include cut-through, store and forward, and a modified version of the first two methods. Which statement about switching methods is true? A. The store and forward method has low latency B. The cut through method of switching has high latency C. The modified version holds the packet in memory until 50 percent of the packet reaches the switch D. The modified version holds the packet in memory until the data spoon of the packet reaches the switch

3 Answers  

---

Which of the following describe full-duplex transmission? A.) Uses a single wire B.) Data transmission in only both directions, but only one way at a time C.) Uses a point-to-point connection from the transmitter of the transmitting station to the receiver of the receiving station D.) Data transmission in only one direction

1 Answers  

---

Windowing is a type of : A.) Negative acknowledgement B.) Address resolution C.) Layer transition mechanism D.) Flow control

1 Answers  

---

why we use AS no. in IGRP and EIGRP?

2 Answers   HCL,

---

What was the key reason the International Organization for Standardization released the OSI model? A. users could access network servers faster B. different vendor networks could work with each other C. the industry could create a standard for how computers work D. network administrators could increase the overall speed of their network

1 Answers  

---

Identify the command to run 'setup'? A.) Router(config)#setup B.) Router?setup C.) Router#setup D.) Router>setup

1 Answers   Karrox,

---