Answer / Sanjev Kumar Gupta

DLCI (Data Link Connection Identifier) is a number that identifies virtual circuits in Frame Relay networks.

Which statement should you use to deny FTP access (only) from network 210 93 105 0 to network 223 8 151 0? A. access list 1 deny 210 93 105 0 0 0 0 0 any eq ftp access list 1 permit any B. access list 100 deny tcp 210 93 105 0 0 0 0 255 223 8 151 0 0 0 0 255 eq ftp C. access list 100 deny ip 223 8 151 0 0 0 0 255 any eq ftp access list 100 permit hp any any D. access list 100 deny tcp 210 93 105 0 0 0 0 255 223 8 151 0 0 0 0 255 eq ftp access list 100 permit ip any any

1 Answers  

---

What is the mau?

1 Answers  

---

Port selection is done at which layer of OSI reference model?????

4 Answers  

---

The two sublayers of the IEEE Data Link Layer are which of the following? A.) Link and Logical Control B.) Data Link and LLC C.) Logical Link Control and Media Access Control D.) Data Link and MAC

3 Answers  

---

What are the types of resource sharing?

1 Answers  

---

When determining whether or not to route a LAN segment, which rule of thumb do you use? A.) 60/40 B.) 50/50 C.) 80/20 D.) 90/10 E.) 70/30

1 Answers  

---

You have a Class B network address divided into 30 subnets. You will add 25 new subnets within the next year. You need 600 host IDs for each subnet. Which subnet mask should you use? A.) 255.254.0.0 B.) 255.192.0.0 C.) 255.255.252.0 D.) 255.255.248 0

1 Answers  

---

Hi, I have packet tracer 5.0. I want to test intervlan routing routing. Can someone plz tell me about intervlan routing?

1 Answers  

---

Identify the command that specifies Serial 0 in slot 1? A.) Router(config)# interface serial1/1 B.) Router(config)# interface serial1/0 C.) Router(config)# interface serial0.1 D.) Router(config)# interface serial0/1

4 Answers  

---

Which of the following describe SMTP? A.) Used for downloading files to the router. B.) Used for sending e-mail. C.) Uses TCP. D.) Uses UDP. E.) Uses port 25. F.) Used for managing IP devices.

1 Answers  

---

In the command "router igrp 109" what does 109 signify? A. an autonomous system B. any network number which the router is attached to C. the allowable length of the routing table D. the network socket number

1 Answers  

---

The following is partial output from a routing table ; '192.168.10.0 [100/1300] via 10.1.0.1, 00:00:23, Ethernet1' Which routing protocol is being used? (assuming defaults have not been changed) A.) OSPF B.) RIP C.) BGP D.) IGRP

1 Answers  

---