Identify 3 IP routing protocols? A.) RIP B.) AURP C.) OSPF D.) IGRP E.) ARP F.) ICMP

2 Answers  

---

Which of the following is a valid extended IP access-list? A.) router(config)# access-list 101 permit tcp host 172.16.30.0 any eq 21 log B.) router# access-list 101 permit tcp host 172.16.30.0 any eq 21 log C.) router(config)# acess-list 101 permit any any 172.16.30.0 D.) router(config)# access-list 101 permit ip host 172.16.30.0 any eq 21 log

2 Answers   HCL,

---

What is difference between static and dynamic routing?

0 Answers  

---

1>What do you mean by Networks and Networking? 2>Difference between Vlan And Sub Interface Vlan? 3>What is Fiber Optic Media Converter? 4>What is Firewall? 5>Difference Between Layer2 and Layer3 Switch? 6>What is the function of Multilayer Switch? 7>Expalin STP? What is the Difference between STP and MST? 8>What is the Function of VTP?Explain the modes of VTP? 9>What kind of Message VTp will Send? 10>What is the Difference between Normal and Manageable Switch? 11>Difference between Local Vlan and End to End Vlan? 12>Difference between Distance Vector and Link State Routing protocol? 13>What do you mean by Backbone Fast Port? 14>what is Root Guard and BPDU Guard?

0 Answers   Gemini, SpectraNet,

---

from last ten days i watched that no any new questions are placed in ccna catogarey.so plz place the questions it is very use full to beginers like us

2 Answers   HCL,

---

Identify the switching method that examines the destination MAC address as the frame is being received then begins forwarding the frame prior to receiving the entire frame? A.) Fragment-free B.) Store and Forward C.) Cut-through D.) Fast forward

2 Answers  

---

When the router runs out of buffer space, this is called ________. A. Source Quench B. Redirect C. Information Request D. Low Memory

2 Answers  

---

What is the name of best path in eigrp protocol?

0 Answers  

---

When you use the Cisco IOS command show configuration on a router which part of the output shows the specific conferred IP addresses and shored masks? A. the IP host table B. the interfaces output C. each section of the output D. the global configuration statements E. the section under the autonomous system number

1 Answers  

---

Identify the 2 hardware components used to manage and/or configure a router? A.) Auxiliary port B.) ROM port C.) Management port D.) Console port

3 Answers  

---

Why would you use static routing instead of dynamic routing? A.) When you want automatic updates of the routing tables B.) All the time C.) When you have very few routes and want to conserve bandwidth D.) When you have a gateway of last resort

1 Answers  

---

What is the syntax to add a banner to the Cisco router? A.) motd banner # B.) banner C.) banner motd # D.) banner #

2 Answers  

---