The following is partial output from a routing table ;
'192.168.10.0 [100/1300] via 10.1.0.1, 00:00:23, Ethernet1'
Which routing protocol is being used? (assuming defaults
have not been
changed)
A.) OSPF
B.) RIP
C.) BGP
D.) IGRP
Answer / guest
IGRP [100/1300] Administrative distance value for IGRP is 100
Is This Answer Correct ? | 2 Yes | 0 No |
Inverse ARP serves what purpose? A.) Method for a local router to introduce itself to the remote end of the connection B.) Broadcast a routing table update C.) Identify MAC addresses if the IP address is known D.) Sent every 10 seconds used to verify the Frame Switch is still active
When using access lists, it is important where those access lists are placed. Which statement best describes access list placement? A. Put standard access lists as near the destination as possible. Put extended access lists as close to the source as possible. B. Put extended access lists as near the destination as possible. Put standard access lists as close to the source as possible. C. It isn't import where access lists are placed since the router will read and cache the whole list. D. Put access lists as close to corporate headquarters as possible.
When configuring a router utilizing both physical and logical interfaces, what factor must be considered in determining the OSPF router ID?
Hey Folks how are you i guess some of guys are newly visitors of this site so let me introduce my self. I am jitendera kumar sinha working for cisco system (india)( Network engineer L2) and i was also a regular Visitors of this site and i have provided lots of answer and i do not know how many are correct :-) By the way i am here again to learn some thing and share my knowledge which is beyond CCNA Scope and and it is some where related to ccnp ( switching )and ccnp Security as i am pursuing ccnp security so i am going to start the topics from switching and will share my knowledge and try to brush-up my knowledge.... so let me know any topic in switching where you are facing difficulty and i will try to solve it so please post one topic and i will reply weekly as i am getting time on Sunday only
Select the correct statements about PPP and SLIP for WAN communications? A. PPP uses its Network Control Programs (NCPs) component to encapsulate multiple protocols. B. PPP can only transport TCP/IP C. SLIP can only transport TCP/IP. D. SLIP uses its Network Control Programs (NCPs) component to encapsulate multiple protocols.
what is unike ip address
Utilizing RIP, what is the limit when it comes to the number of hops?
Why we used Virtual MAC in GLBP
Identify the command to configure the configuration-register? A.) Router# config-register 0x2102 B.) Router(config)# config-register 0x2102 C.) Router(config-reg)# 0x2102 D.) Router> config-register 0x2102
What does the Spanning Tree Algorithm (STA) do? A.) Restore lost frames B.) Builds routing tables for routing through an internetwork C.) Forward packets through a switch D.) STA is implemented by STP to prevent loops
Which processes does TCP, but not UDP, use? A. Windowing B. Acknowledgements C. Source Port D. Destination Port
Identify the hardware component used to store buffers, tables, running-configuration etc? A.) NVRAM B.) ROM C.) RAM D.) Flash