What does a Standard IP Access-list use as test criteria? A.) IP source address B.) IP source and destination address, protocol numbers and port numbers C.) IPX source and destination address D.) Source MAC address

2 Answers  

---

When discussing static routes, what is the gateway parameter used for? A.) Determining the dynamic route B.) Defining the subnet C.) Defining the Administrative Distance D.) Determining the next hop

1 Answers  

---

What is link aggregration?? How many types of protocol are used on that???

3 Answers   Hathway,

---

What do we check while configuring the server?

0 Answers  

---

Of the following, which reason applies to dividing a large network into two or more smaller networks? Performance Security Address Management All of the above

2 Answers  

---

Which types of packets used in EIGRP?

1 Answers  

---

what is the difference between 1 router and switch 2 router and hub 3 hub and switch 4 bridge and switch

1 Answers   Hathway,

---

Based upon the 1st octet rule identify the range for a Class A address? A.) 1 - 126 B.) 192 - 223 C.) 128 - 191 D.) 1 - 191

1 Answers  

---

Identify the IPX standard access-list number range? A.) 600 - 699 B.) 1000 - 1099 C.) 1 - 99 D.) 100 - 199 E.) 800 - 899

1 Answers  

---

what is the difference between hdlc and ppp protocol

7 Answers   ASD Lab, HCL,

---

Which OSI Reference Layer is concerned with logical addressing? A.) Network B.) Transport C.) Datalink D.) Physical E.) Session

1 Answers  

---

Identify the command to determine if CDP is enabled? A.) show enable cdp B.) show cdp enabled C.) show cdp run D.) show cdp

1 Answers  

---