What is the best Difference between RIP, OSPF, EIGRP

7 Answers   Airtel, Gemini, HP,

---

What do you understand by poe (power over ethernet)?

0 Answers  

---

what is the subnet for the host ip address 172.16.210.0/22

8 Answers   IBM, Microland,

---

What is the juncture at which the CPE ends and the local loop portion of the service begins? A. Demarc B. CO C. Local loop D. Last-mile

1 Answers  

---

Identify 2 features of PPP PAP authentication? A.) Username and password is sent in clear text B.) Authentication messages are sent periodically during the connection C.) More secure than CHAP D.) Remote node is control of authentication process

1 Answers  

---

What is raid in ccna?

0 Answers  

---

Which of the following will apply IPX sap access list 1010 for incoming traffic, assume you are at the interface configuration? A.) ipx input-sap-filter 1010 in B.) ipx input-sap-filter 1010 C.) ipx access-group 1010 in D.) ipx access-list 1010 in

2 Answers  

---

Although Cisco IOS 11.2 and later can auto-detect the LMI type in Frame Relay, which command will force the LMI type to q933a? A.) frame-relay lmi-type q933a B.) encapsulation frame-relay q933a C.) don't need to, it is the default D.) encapsulation q933a E.) encapsulation frame-relay type=q933a

1 Answers  

---

Identify the command to display the status of the Frame Relay virtual circuit? A.) Router# show frame-relay virtual-circuit B.) Router(config)# show frame-relay pvc C.) Router# show frame-relay pvc D.) Router# show virtual

1 Answers  

---

Which of the following will show an extended access list 150? A.) sh access-list 150 B.) sh ip int C.) sh ip access-list D.) sh access-list 150 extended

2 Answers  

---

Which layer is responsible for framing? A.) Application B.) Data Link C.) Physical D.) Network E.) Transport

3 Answers  

---

here is your question sahin Hi Jitendera, If i m not wrong, then in EIGRP, Metric weight is set to K1(Bandwidth)=1, K2(Delay)=0, K3(Reliability)=1, K4(Load)=0, K5(MTU)=0. This is default setting for EIGRP. I knew about it from ICND 2 cisco press book. Three more questions - a) If we change the K value (I mean metric weight)on a router what will happen??? b) When redistribution is necessary in EIGRP. Is there any condition for that??? c) What is reference bandwidth for metric calculation in EIGRP. As we know, in OSPF, on a CISCO router reference bandwidth is 10Mbps.

3 Answers  

---