Answer / shahin

Hey buddy, u asked an interesting question.. Isn't it
funny.... 2 in 1 offer, where do the certification and get a
free job.


Just kidding, its not like that.. its all about the
vacancies & catch it when it knocks your door. U must be gud
in concept & as well as in configuration & understanding
enough the networking circumstances.

Do the well & best of luck. Cheers..

Which of the following statements is false? If your Frame Relay link does not support inverse ARP, you must manually map DLCIs to network Address. One of the major advantages of Frame Relay is its ability to connect to multiple PVCs using only one physical link. DLCI addresses are determined by the network administrator when installing the network. Which of the following statements is false? If your Frame Relay link does not support inverse ARP, you must manually map DLCIs to network Address. One of the major advantages of Frame Relay is its ability to connect to multiple PVCs using only one physical link. DLCI addresses are determined by the network administrator when installing the network. In order for two ends of virtual circuits to communicate using Frame Relay, their network addresses must be mapped to DLCIs.

2 Answers   Wipro,

---

Which OSI layer incorporates the MAC address and the LLC? A.) Data link B.) Network C.) Physcial D.) Transport

4 Answers  

---

how many vlan can be configured on a single switch

12 Answers   IBM, Sigma IT,

---

Which 2 commands shows the Cisco IOS filename? A.) show IOS B.) show ver C.) show flash D.) show mem E.) show NVRAM

1 Answers  

---

IPX routing updates occur how often? A.) Every 30 seconds B.) Every 60 seconds C.) Only as needed D.) When the remote router asks for an update

1 Answers  

---

Can anyone explain the STP Security features. Just like BPDU guard, Root Guard. Hi JITENDERA, i m specially looking for u?????

2 Answers  

---

What is the routing algorithm used by RIP and IGRP? A.) OSPF B.) Link-state C.) Dynamic D.) Distance Vector

3 Answers   Cisco,

---

Identify the command to run 'setup'? A.) Router(config)#setup B.) Router?setup C.) Router#setup D.) Router>setup

1 Answers   Karrox,

---

What is convergence time? A.) The update time B.) The time it takes to reload a router C.) The time it takes for a packet to reach its destination D.) The time is takes for all routers update their tables after a change takes place

2 Answers  

---

What is bgp?

0 Answers  

---

What is hsrp?

0 Answers  

---

what is unike ip address

1 Answers  

---