Which symbol in the router prompt indicates you are in the
privelaged mode?
A. >
B. !
C. #
D. :
- 5 Answers
- 12504 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
C. #
To go to privileged mode, enter the enable command. If an
enable password is not set, the router changes to privileged
mode without asking for a password. If this is the first
time the router is being configured, the router prompts you
for the enable password. Enter the enable password, if a
password is set. The prompt changes to Router#. The pound
symbol (#) indicates that you are in privileged mode.
Source: Cisco Documentation
| Is This Answer Correct ? | 8 Yes | 0 No |
Answer / s.m.feroz ahmed
The symbol which indicates the router in privileged mode is
Hash(#) symbol.
C.#
| Is This Answer Correct ? | 5 Yes | 0 No |
What protocols can you use while testing Trace? A.) DECnet B.) CLNS C.) IP D.) Old Vines E.) Vines F.) Chaos
What does the parameter -- LOG -- do on an IPX access list? A.) The log keyword is not a valid option. B.) Read the LOG to figure out what traffic to deny. C.) Logs the creation of the access list. D.) Logs IPX access control list violations whenever a packet matches a particular access list entry. E.) Ensures the IPX protocol places a log in the fireplace.
Which device works at the Network Layer of the OSI model? Router Switch Bridge Hub
how can we block remote desktop for some user from cisco router through aaccess-list
Identify the default values that make up IGRP's composite metric? A.) Bandwidth B.) Load C.) Reliability D.) MTU E.) Delay
Explain what is the size of hello packets in eigrep protocol?
Which configuration mode and command combination sets the bandwidth metric of a Frame Relay connection? A. router(config)# clock rate 56 B. router(config)# bandwidth 56 C. router(config)# bandwidth 56000 D. router(config)# clock rate 56000
Which command line option will determine what traffic is interesting enough to establish a dialup connection? A.) dialer map B.) dialer string C.) dialer in-band D.) dialer-list E.) dialer negotiation
Explain what are partial updates?
Which cable called v.35?
Which device listed below provides clocking for the line? A.) DCE B.) CPE C.) CO D.) DTE E.) Demarc
What is trigger rip and from which ios version it starts?
CCNA 
