Interested to Buy Any Domain ? << Click Here >> for more details...
Which device listed below provides clocking for the line?
A.) DCE
B.) CPE
C.) CO
D.) DTE
E.) Demarc
- 1 Answers
- 4466 Views
- I also Faced
- E-Mail Answers
Answer / guest
Answer: A
The Data Circuit-terminating Equipment (DCE) is responsible for
providing the clocking on the wire.
HINT: When You see the 'C' in 'DCE', think 'Clocking' t.
| Is This Answer Correct ? | 5 Yes | 0 No |
Which three of the following are true statements about connection-oriented sessions? A.) The segments delivered are acknowledged back to the sender upon their reception B.) Any segments not acknowledged the are retransmitted by the receiver C.) A manageable data flow is maintained in order to avoid congestion, overloading and loss of any data D.) Segments are sequenced back into their proper order upon arrival at their destination
Identify the purpose of the TCP 3 step handshake? A.) Setup a un-reliable connection B.) Initialize routing tables C.) Synchronize sequence numbers between hosts D.) Connection tear down process
what is ip address and what is the difference between the ip address and mac address why we are not using mac address instead of ip address
Of the following switching types, which one has the lowest latency? A.) Cut-through B.) Fragment Free C.) None D.) Store-and-forward
When you enter router passwords during the setup dialog what is the difference between enable and the enable secret passwords? A. The enable password is encrypted B. The enable secret password uses IPSec password authentication C. The enable secret password cannot be seen as clear text when viewing the configuration D. The enable secret password acts as a backup in case the enable password is compromised
Mention the ranges for the private IP?
What are the types of communication in ipv6 ?
Which two statements are true? (Choose two) A. Ethernet 802.3 utilizes a half duplex method for data transfer B. In a 100 MBS point to point connection a full duplex connection can provide 400 Mbs of data transfer C. Ethernet switches can use the full duplex mode to connect multiple nodes on a single pod of a switch D. Full duplex Ethernet takes advantage of UTP using one pair for transmission and the other pair for reception
Why subnetting is used?
What is fcs?
In stp which protocol is used for detrming root port root bridge ,forwarding port and blocking port
Identify the command to display the hardware platform information? A.) show all B.) show platform C.) display hardware D.) show version
CCNA 
