Interested to Buy Any Domain ? << Click Here >> for more details...
Which of the following is a layer 2 device?
A.) Switch
B.) Router
C.) Repeater
D.) Hub
- 4 Answers
- 19948 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / guest
Answer: A
A Hub and Repeater are layer 1 devices. A Router is a layer
3 device.
| Is This Answer Correct ? | 27 Yes | 2 No |
Answer / vipin
well definately the answer is a Switch, since we to be
precisely say that bridge is a layer 2 device. But actually
here there is no mentioning of bridge therefore it can be
said as a layer 2 switch which is another name for bridge.
| Is This Answer Correct ? | 8 Yes | 3 No |
Answer / kapilasdhir
A. Switch.
Switch are also Two type:-
1. Normal Switch-----Layer 2
2. Manageable Switch--Layer 3
| Is This Answer Correct ? | 8 Yes | 5 No |
What is Transport and Tunnel mode?
What purpose does aging serve in a link state protocol?
Which command will give the following output: Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int * 0 CTY - - - - - 0 0 0/0 - 1 AUX 9600/9600 - - - - - 0 0 0/0 - * 2 VTY - - - - - 2 0 0/0 - 3 VTY - - - - - 0 0 0/0 - 4 VTY - - - - - 0 0 0/0 - 5 VTY - - - - - 0 0 0/0 - 6 VTY - - - - - 0 0 0/0 -
Identify the command that forces the router to load into ROM mode upon a reload? A.) boot system rom B.) rom boot C.) boot system flash rom D.) boot router rom
Which of the following is an example of a Transport Layer protocol? Ethernet IP TCP RS-232
How can we configure Inter-VLAN in Layer 3 Switch? Remember one thing without Router.
You can access three forms of WAN services with Cisco routers. Select the three forms: A. Switched or relayed services B. Interface front end to IBM enterprise data center computers C. Using protocols that connect peer-to-peer devices like HDLC or PPP encapsulation. D. IPX/SPX E. NetBEUI
Identify the purpose of ICMP? A.) Avoiding routing loops B.) Send error and control messages C.) Transporting routing updates D.) Collision detection
You have a Frame Relay link on serial 1. Which command displays the Local Management Interface (LMI) data link connection identifier (DLCI) and bandwidth for that link? A. show interface serial1 B. show frame-felay serial1 C. show protocol frame-relay serial1 D. show serial1 encapsulation frame-relay
What is etherchannel?
in router we use config# ip host router2 ipaddress we use it for ping the neighbor router using name provided by us ..........instead of ip address in this max how many ip address can be assigned thanks
Tell me how many reserve ports?
CCNA 
