Answer / guest

Answer: A, B & C

A modem, CSU/DSU (Channel Service Unit/Data Service Unit),
or TA/NT1

(Terminal Adapter/Network Termination 1) can be used to
convert the user

data from the DTE into a form acceptable to the WAN
service's facility.

Explain how many tables are in ospf protocol?

0 Answers  

---

Differentiate User Mode from Privileged Mode?

0 Answers  

---

What is 100BaseFX?

0 Answers  

---

Which layer is responsible for negotiating data transfer syntax? A.) Network B.) Session C.) Application D.) Transport E.) Presentation

2 Answers  

---

What utility can you use to see the path a packet takes through an internetwork? A.) Route B.) SNMP C.) Trace D.) Ping

3 Answers  

---

Identify the 2 hardware components used to manage and/or configure a router? A.) Auxiliary port B.) ROM port C.) Management port D.) Console port

3 Answers  

---

The maximum distance on a 10BaseT network from the hub to a workstation is which of the following? A.) 500 meters B.) 1000 meters C.) 100 meters D.) 1500 meters

2 Answers  

---

In IOS boot sequence if the flash is erased, and there is no access to TFTP server, and we can't load the partial IOS from ROM. Is there any possiblity that we can still boot the router/switch from external PC in which the IOS is installed?

6 Answers  

---

What is the name of distance vector algorithm?

0 Answers  

---

Inverse ARP serves what purpose? A.) Method for a local router to introduce itself to the remote end of the connection B.) Broadcast a routing table update C.) Identify MAC addresses if the IP address is known D.) Sent every 10 seconds used to verify the Frame Switch is still active

1 Answers  

---

Using the access-list command, 'access-list 1 deny 2.2.2.2', what else must be done to stop host 2.2.2.2 from sending any traffic out of physical interface E0, while still allowing other traffic? A.) In global mode, Add a line - 'access-list 1 permit 0.0.0.0 255.255.255.255' B.) On interface E0, Add a line - 'access-group 1 in' C.) In global mode, Add a line - 'access-list 1 permit all' D.) On interface E0, Add a line - 'access-list 1 in' E.) On interface E0, Add a line - 'access-list 1 out' F.) On interface E0, Add a line - 'ip access-group 1'

1 Answers  

---

When we use router?

0 Answers  

---