Sequence and acknowledgement numbers are used for?
A.) Layer transitioning
B.) Flow control
C.) Port number addressing
D.) Reliability
- 1 Answers
- 5113 Views
- I also Faced
- E-Mail Answers
How do you depict an IP address?
what is nat.types of nat
Which three pieces of CDP information about neighbours routers are displayed on your console terminal? (Choose three) A. neighbours router a host name B. the neighbours router a hardware platform C. up to one address for each protocol supported D. up to two addresses for each protocol supported
Tell me which cable called roll-over?
Which of the following would not be displayed by the command ?sho cdp neighbor detail?? A.) The incoming/outgoing interface. B.) The hardware platform. C.) One address per protocol. D.) Amount of Flash Memory Available E.) The routers hostname. F.) The subnet mask, if IP is configured.
How does cut-through LAN switching work?
Which three of the following are true statements about connection-oriented sessions? A.) The segments delivered are acknowledged back to the sender upon their reception B.) Any segments not acknowledged the are retransmitted by the receiver C.) A manageable data flow is maintained in order to avoid congestion, overloading and loss of any data D.) Segments are sequenced back into their proper order upon arrival at their destination
Which of the following are examples of the Session Layer? A.) TCP B.) LLC C.) SQL D.) NFS E.) Token Ring
What is a disadvantage of using a connection oriented protocal such as TCP? A. Packet acknowledgement may add overhead B. packets are not tagged with sequence numbers C. Loss or duplication of data packets is more likely to occur D. The application layer must assume responsibility for correct searchers of the data packets
Select the compression protocols for PPP? A. Stac B. Predictor C. Quality D. Magic Number
The following is partial output from a routing table, identify the 2 numbers in the square brackets; '192.168.10.0 [100/1300] via 10.1.0.1, 00:00:23, Ethernet1' A.) 100 = metric, 1300 = administrative distance B.) 100 = administrative distance, 1300 = hop count C.) 100 = administrative distance, 1300 = metric D.) 100 = hop count, 1300 = metric
can we measure how much a host exact bandwidth using by a network cable which is communicating over the network? options: 1- via Router 2- Switch, 3- other device... if yes.. then how ( with every option)
CCNA 
