Which layer is responsible for determining if sufficient
resources
for the
intended communication exists?
A.) Application
B.) Network
C.) Session
D.) Presentation
E.) Transport
- 3 Answers
- 5988 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
If i had 400 computers set in a site how many VLAN i should configure so that i can share a proper bandwith,and also i had two lease line connection of 2Mbps each,
What layer can optionally support reliability? A.) Transport B.) IP C.) Physical D.) Network E.) Sub-physical layer
Which NetWare protocol provides link-state routing? A. NLSP B. RIP C. SAP D. NCP
Identify the command to configure the IP address 172.16.100.5 255.255.255.0? A.) Router(config-if)# ip address 172.16.100.5 255.255.255.0 B.) Router(config)# ip address 172.16.100.5 C.) Router# ip address 172.16.100.5 255.255.255.0 D.) Router(config)# ip address 172.16.100.5 255.255.255.0
what is the default ad value of the interface directly coneted to router. as for exmaple ad value of ospf is 90 then from ehternet the network is conected whta is difault value of that directly conected interface. what is the defalt ad value of bgp whta is access llist and how many type of access list what is vlan what is vpn how e congigure the router what is mpls these are the question skrd to me at tcs i have replyed all ecxept the first one
what does the clock rate do?
In configuring a router, what command must be used if you want to delete the configuration data that is stored in the NVRAM?
What is raid in ccna?
Which of the following use PVCs at layer 2? A.) X.25 B.) HDLC C.) Frame relay D.) ISDN
hi friends i donot know this is the networking question or not but if you help me then i will thankfull to you the problem is like that in my comnay there are 200 user which log one at a time now only one user is not able to get the dhcp address and othr are geting the dhcp my company sys admin is saying that this is the n/w fault while i am saying that this is not the n/w fault for the cleaerfication of my side i take a straight workng cable and connect that user directly to my cisco 24port switch now problem is stiil like that but one thing i wan to say he is geting manually ip and able to access internet he is able to ping the server but whrnever he tyeme \\<ip address of server> error comes like networl path provided not accepted by provider some thing like that. my systm admin is saying that i have o do somthing on my firewall but i am saying that no issue with firewall in that i connect my latop to the spefic port from where the user is conected then i am geting dhcp ip address and i am able to connect the server also i donot know why this is happen my syadmin is senior to me so i canot blame him plz help e what to do i am very weak in the filed of systym jitendera kumar sinha
What is the command to manually enter a static route? A.) IP route network B.) IP route C.) IP route < destination network> D.) IP route
Utilizing RIP, what is the limit when it comes to number of hops?
CCNA 
