What two types of PPP data compression are available using
Cisco IOS?
A.) Predictor
B.) DoubleSpace
C.) Stacker
D.) PAP
E.) ZIP
F.) CHAP
- 2 Answers
- 7740 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / guest
Answer: A C
Stacker and predictor have similar compression rates.
Stacker uses more CPU, while predictor uses more RAM.
| Is This Answer Correct ? | 4 Yes | 0 No |
Answer / prasanna
D F
two types of ppp
1 pap-password authentication protocol
2 chap- challenge handshake authentication password
| Is This Answer Correct ? | 0 Yes | 1 No |
What IP command would you use to test the entire IP stack? A.) Stack-test B.) Arp C.) Telnet D.) Ping E.) Trace
Identify the command to display all the valid commands at the given mode? A.) Help all B.) Help C.) All commands D.) ?
What are the three phases of PPP session establishment? A. Link establishment phase B. Authentication phase C. Network layer protocol phase D. Handshake phase E. Dial-in phase
Which of the following are Session Layer standards? A.) ASCII and EBCDIC B.) MPEG and MIDI C.) NFS and SQL D.) JPEG and PICT
Station A is transmitting data to station B, and expects an acknowledgment after every 400 bytes. After transmitting data for a while, the two stations determine the line is reliable and change to expecting and acknowledgement every 600 bytes. This is an example of (pick the best answer only): A.) BECN B.) Sliding Windows C.) Poison Reverse D.) Countdown timers E.) Split Horizon F.) Count to infinity
which defined peer ip address an local subnet belong to crete? (Choose two)
ok this is practical senario question how can we comunicate two diffrent network host by i single 1603 sires of cisco router rember that the cisco series of that router have singe 100mbps ethernet now think think write all command answer is so simple i wiil; give the answer after 20 visit til then wait
Define the logical link control?
What is the network subnet?
any body can send me CCNA voice simulator practice exam software.
Which two steps are part of the process of creating Frame Relay subinterfaces on a point to point connection? (Choose two) A. configure the router to forward all broadcast packets B. remove any network address assigned to the physical interface C. configure the local data link connection identifier (DICI) for the subinterfaces D. cartoon the total committed information rate (CIP) available among the subinterfaces
What is the difference between switch and hub?
CCNA 
