HI ALL , wanted to know if the rstp protocol.. rapid
spanning tree protocol .. is imp to study with ccna's point
of view or study of STP will be enough.. in some books rstp
is nt given like todd lamle however in icnd2 its explained
in detail.. please suggest asap .. thanks ..
Answers were Sorted based on User's Feedback
Answer / anil kumar
RSTP rapid spanning tree protocol
when ever network tropology changed the rstp re calculate
the election and stabilished new route.
| Is This Answer Correct ? | 0 Yes | 0 No |
Answer / i donot know who i am
HI
waht ever u r studing in ccna it is basic only so after
doing the ccna when ever u go to the ccnp (switching) it
will come there
| Is This Answer Correct ? | 0 Yes | 1 No |
What does a Standard IP Access-list use as test criteria? A.) IP source address B.) IP source and destination address, protocol numbers and port numbers C.) IPX source and destination address D.) Source MAC address
Write out a config to permit only the below MAC address to pass traffic through a port on your switch. in another way writhe a confrigation which permit only mac address trfaic through a port of your switch
What does the trace response !H mean? * A: Network unreachable * B: Not forwarded due to ACL restriction * C: Protocol unreachable * D: Port could not be reached
Which two statements about IP RIP are true? (Choose two) A. It limits hop counts to 31 B. It is a link state routing protocol C. It uses autonomous system numbers D. It is capable of load sharing over multiple paths E. It uses bandwidth as the metric for path selection F. It broadcasts updates every 30 seconds by default
When using RIP, routing updates are broadcast every ____ seconds. A. 30 B. 10 C. 60 D. 90
Which of the following is a valid extended IP access-list? A.) router(config)# access-list 101 permit tcp host 172.16.30.0 any eq 21 log B.) router# access-list 101 permit tcp host 172.16.30.0 any eq 21 log C.) router(config)# acess-list 101 permit any any 172.16.30.0 D.) router(config)# access-list 101 permit ip host 172.16.30.0 any eq 21 log
What is the difference between switch and hub?
Which command would show all Ethernet interfaces with IPX configured on them? A.) show interface ipx ethernet B.) show ipx interface C.) show ipx interface ethernet D.) show ipx E.) show version F.) show run
Access lists are numbered. Which of the following ranges could be used for an IP access list? A. 600 - 699 B. 100 - 199 C. 1 - 99 D. 800 - 899 E. 1000 - 1099
Identify the 3 Internet layer IP protocols? A.) NetBios B.) IPX C.) ARP D.) IP E.) RARP
The benefits to segmenting with Bridges are which of the following? A.) Scalability B.) Datagram filtering C.) Manageability D.) Reliability
What ISDN protocol specifies concepts, terminology, and services? A.) Q B.) S C.) I D.) E