Identify 3 Fast Ethernet technologies?
A.) 100 Base FastEther
B.) 100 Base FX
C.) 100 Base T4
D.) 100 Base TX
What is the default IPX Ethernet encapsulation? A.) SNAP B.) Arpa C.) 802.2 D.) Novell-Ether E.) SAP
What is a protocol
What is the standard ISDN term for a native ISDN telephone? A.) ET B.) TE1 C.) TE2 D.) LE E.) TA
what is router,bridges,hubs?
Explain the types of resource sharing?
Which fields of an IP packet provide for fragmentation of datagrams to allow differing MTUs in the internet? A. Identification B. Flags C. Frag Offset D. Type of Service E. Total Length
Identify the command to reload the router? A.) Router(config)# reload B.) Router# reset C.) Router# reload D.) Router> reload
Identify the 3 key features of the Cisco Discovery Protocol? A.) Off by default B.) Will allow for the discovery of layer 3 addresses on neighbor routers C.) Verify connectivity D.) Open standard E.) Does not require any layer 3 protocols to be configured
Identify the true statements about the following access list: Access-list 101 deny tcp 192.10.172.0 0.0.0.255 any eq 23 Access-list 101 permit ip any any A.) This access list prevents the host 192.10.172.0 from telneting B.) This access list prevents any telnet traffic from subnet 192.10.172.0/24 C.) This access list filters some telnet access D.) This access list denies any telnet traffic to subnet 192.10.172.0/24 E.) This access list is invalid F.) The netmask on the this access list is reversed
Which type of switching reads just the address portion of the frame and then immediately starts forwarding it? A.) Cut-Through B.) Store-and-Forward C.) Tabling D.) Routing E.) Inverse ARP F.) Fast Forward
Which layer defines bit synchronization? A.) Application B.) Network C.) Transport D.) Physical E.) Session F.) Session
which is following route will be used to froword data in a situation where a routing table tables contains static ,RIP,IGRP routes destined to the same network with each set to its default administrative distance