Routers that have Flash memory typically have a ore loaded
copy of place IOS software. Which command should you use to
make a backup copy of the software image onto a given
A. copy flash tftp
B. save copy to tftp
C. write backup tftp
D. write, backup -server-name-
E. copy backup to -server-name-
Answer / guest
|Is This Answer Correct ?||2 Yes||0 No|
Which configuration mode and command combination sets the bandwidth metric of a Frame Relay connection? A. router(config)# clock rate 56 B. router(config)# bandwidth 56 C. router(config)# bandwidth 56000 D. router(config)# clock rate 56000
Which command successfully pings an individual IP address? A. Router> ping 220.127.116.11 B. Router# ping 18.104.22.168 C. Router> ping 22.214.171.1246 D. Router# ping 126.96.36.199
Hi, Can any one please tell me the experience of their CCNA interview,and please tell me all the questions they asked in the interview. Many Thanks...
Using the TCP/IP protocol suite a message is sent from host A to a destination IP address on the same LAN. How does host A determine the destination of MAC address? A. It uses a proxy APP B. It uses APP requests C. It uses RARP requests D. It uses a router lookup table
Which of the following is not a characteristic of link-state routing protocols? ❍ A. VLSM support ❍ B. Route summarization at any bit level ❍ C. Full routing updates at regular intervals ❍ D. Discontiguous network support
What type of frame does CDP use to gather information about it's neighbors? A.) TCP/IP B.) Novell-ether C.) Subnetwork Access Protocol (SNAP) D.) Ethernet_II
Which IP Address Class can have 64,000 subnets with 64,000 hosts per subnet? A. Class B B. Class A C. Class C D. Class D
Identify IPX SAP and it's purpose? A.) Sonet Access Pipe - interface to Sonet ring B.) Service Advertising Protocol - advertise services C.) Server Appletalk Protocol - appletalk directory services D.) Service Access Point - identify upper layer protocols
what is full form of rst,smtps & http?
Identify the hardware component that stores the backup configuration? A.) RAM B.) NVRAM C.) Flash D.) ROM
In order to configure a Frame Relay subinterface with IP identify the 2 commands that must be configured on the physcial interface? A.) Router(config-if)# encapsulation frame-relay B.) Router(config-if)# no ip address C.) Router(config-if)#encapsulation subinterface frame-relay D.) Router(config)# subinterface s0 encapsulation frame-relay
Explain the term 'unicast'.