Identify the protocol to test connectivity without
configuring any

layer 3

protocols?

A.) TCP

B.) Ping

C.) IP

D.) CDP

E.) Telnet



Identify the protocol to test connectivity without configuring any layer 3 protocols? A.) ..

Answer / guest

Answer: D

Is This Answer Correct ?    2 Yes 0 No

Post New Answer

More CCNA Interview Questions

Differnce between the communication and transmission?

1 Answers  


what is subnet mask?

5 Answers   HCL,


Which classes are assignable?

1 Answers  


Identify the 2 characteristics that TCP and UDP share in common? A.) Both use port numbers to identify upper level applications B.) Operate at the Network layer C.) Both are Transport protocols D.) Both are reliable communications

3 Answers  


The "ipx delay number" command will allow an administrator to change the default settings. What are the default settings? A. For LAN interfaces, one tick; for WAN interfaces, six ticks B. For LAN interfaces, six ticks; for WAN interfaces, one tick C. For LAN interfaces, zero ticks; for WAN interfaces, five ticks D. For LAN interfaces, five ticks; for WAN interfaces, zero Ticks

1 Answers  


Which command loads a new version of the Cisco IOS into a router? A. copy flash ftp B. copy ftp flash C. copy flash ftp D. copy tftp flash

2 Answers  


Identify 3 characteristics regarding IP access-lists? A.) Can be configured as a standard access-list B.) Can be run from another router running IP C.) Can be configured as a named access-list D.) Are the same as IPX access-lists E.) Can be configured as an extended access-list

1 Answers  


Identify the command that configures the bandwidth to 56K? A.) Router(config-if)# bandwidth 56000 B.) Router(config-if)# bandwidth 56k C.) Router(config)# bandwidth 56 D.) Router(config-if)# bandwidth 56

1 Answers  


There are 2 types of PPP authentication supported by the Cisco IOS. What are they? A.) PAP B.) PREDICTOR C.) MD5 D.) CHAP E.) STACKER F.) MSCHAP

1 Answers  


Explain the difference between simple authentication and md5?

1 Answers  


Identify the command that forces the router to load into ROM mode upon a reload? A.) boot system rom B.) rom boot C.) boot system flash rom D.) boot router rom

1 Answers  


hi im ccna certified im searching 4 job in networking domain can any guide wats the rite way of job approach ,wat r the rite sites for searching job im eagerly 4 ur replies

1 Answers  


Categories