1. Categories >> Certifications >> Cisco Certifications >> CCNA
  2. Suggest New Category

Identify the command that configures the bandwidth to 56K?

A.) Router(config-if)# bandwidth 56000

B.) Router(config-if)# bandwidth 56k

C.) Router(config)# bandwidth 56

D.) Router(config-if)# bandwidth 56

Question Posted / guest


Identify the command that configures the bandwidth to 56K? A.) Router(config-if)# bandwidth 56000..

Answer / guest

Answer: D

Is This Answer Correct ?    2 Yes 3 No

Post New Answer

More CCNA Interview Questions

Identify 2 characteristics of PPP? A.) Uses LLC to establish the link B.) Default serial encapsulation C.) Support multiple layer 3 protocols D.) Offers two types of authentication; PAP and CHAP

3 Answers  

How many hope count rip or rip2 can send updates?

1 Answers  

When you use the Cisco IOS command show configuration on a router which part of the output shows the specific conferred IP addresses and shored masks? A. the IP host table B. the interfaces output C. each section of the output D. the global configuration statements E. the section under the autonomous system number

1 Answers  

Can you explain the difference between trusted and untrusted networks?

2 Answers   CCIE, Wipro,

How to find Router Serial interface MAC address?

9 Answers   Wipro,

Which of the following are Transport layer protocols? A.) UDP B.) TCP C.) NBP D.) IP E.) SPX

3 Answers  

What does the "IPX maximum-paths 2" command accomplish? A. It enables load sharing on 2 paths if the paths are equal metric paths. B. It sets up routing to go to network 2. C. It is the default for Cisco IPX load sharing. D. It enables load sharing on 2 paths if the paths are unequal metric paths.

3 Answers  

What is difference between baseband and broadband transmission in ccna?

1 Answers  

hello friends im murtaza frm indore... and my question is that im doing hardware engenering and networking and im intrested in make a good career in networking so can you suggest.. which institiue is good for me...plzzz replyy im waiting...

1 Answers  

what is distance vector protocol link state protocol and what is the diffrence between them

5 Answers   Wipro,

I have layer 3 Cisco 3560(Multilayer) switch right.How we can configure sub interface & Inter VLAN(we have vlan 2,3 & 10 ),Each VLan talk with each other?

4 Answers   IBM,

A big part of the overhead on a network is broadcasts. You divide a large number of hosts into smaller individual networks and separate them with the proper device According to proper networking terminology you have created separate _______________________, User Domains Broadcast Domains Collision Areas Broadcast Areas

1 Answers  

For more CCNA Interview Questions Click Here
Categories