Identify the 2 commands that copies the configuration in NVRAM to RAM? A.) copy backup-config running-config B.) configure nvram C.) copy startup-config running-config D.) configure memory

2 Answers  

---

We have one router,we r using two routing protocol eigrp 90 net 1.1.1.0/16, ospf 110 net 1.1.1.0/24 on same router, Is it possible?

6 Answers   Wipro,

---

Which two statements about IP RIP are true? (Choose two) A. It limits hop counts to 31 B. It is a link state routing protocol C. It uses autonomous system numbers D. It is capable of load sharing over multiple paths E. It uses bandwidth as the metric for path selection F. It broadcasts updates every 30 seconds by default

1 Answers  

---

What is the checksum?

0 Answers  

---

How do you disable CDP on the entire Router? A.) Router#no cdp run B.) Rotuer(config-if)# no cdp enable C.) Router(config)# no cdp enable D.) Router(config)# no cdp run

1 Answers  

---

HI ALL! RECENTLY I COMPLETED MY MCITP, CCNA COURSE, I AM PLANNING TO DO CCNA CERTIFICATION, ANYBODY PLZ SUGGEST ME HOW MUCH TIME (MONTHS) REQUIRED TO PREPARE FOR CCNA, BOOKS, JOB SCOPE IN INDIA, QUALIFICATION REQUIRED, ANY JOB FOR FRESHERS? YOUR GOOD ADVISE IS HIGHLY APPRECIATED. Reg.Khaleel

2 Answers   IBM,

---

Which two statements about frame tagging are true? (Choose two) A. A filtering table is developed for each switch. B. Frame tagging assigns a unique user defined ID to each frame. C. A unique identifier is placed in the header of each frame as it is forwarded between switches. D. Frame tagging is a technique that examines particular information about each frame based on user defined offsets.

2 Answers  

---

Identify the switching method that receives the entire frame then dispatches it? A.) Cut-through B.) Receive and forward C.) Store and forward D.) Fast forward

2 Answers  

---

hi im ccna certified im searching 4 job in networking domain can any guide wats the rite way of job approach ,wat r the rite sites for searching job im eagerly 4 ur replies

1 Answers  

---

Which command-line keywords are valid for choosing Frame-Relay LMI types? A.) itu-t B.) dlci C.) ansi D.) rfc 1544 E.) cisco F.) q933a

1 Answers  

---

What is the purpose of Split Horizon? A.) It prevents the regular update messages from reinstating a route that has gone down B.) Information received on an interface cannot be sent back out the same interface C.) Informs all neighbor routers that two routes exist D.) Tells the router the destination is unreachable

1 Answers  

---

what is internetworking.

6 Answers  

---