Interested to Buy Any Domain ? << Click Here >> for more details...
Which command listed below sets the banner message when someone
connects to the router?
A.) message #
B.) banner #
C.) login banner #
D.) description #
E.) login description #
F.) banner motd #
- 2 Answers
- 4662 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
The following selections show the command prompt and the configuration of the IP network mask. Which two are correct? A. Router#term IP netmask-format { bitcount | decimal | hexadecimal } B. Router(config-if)#IP netmask-format { bitcount | decimal | hexadecimal } C. Router(config-if)#netmask-format { bitcount | decimal | hexadecimal } D. Router#ip netmask-format { bitcount | decimal | hexadecimal }
Identify the default serial encapsulation? A.) ISDN B.) HDLC C.) SDLC D.) Frame Relay E.) PPP
How many collision domains are in switch?
friends i have some problem in the acess list plz help me out. purbi sinha. 1 what is the diffrence b/w inbound and out bound access list 2 what is main diffrence betwwen standred acesslist and extended access list 3 where should i keep stnadred access list and exatended access list i mean at which interface and why? 4 why wild card masking is used 5 what is switch febric in switching plz help me out i am litle bit confuse
hi... i am usin packet tracer 5.0.. i hav connect two routers A and B. A has 200.100.25.100 and 1.0.0.1 and router B has 200.100.50.100 and 1.0.0.2... i hav connected 1.0.0.1 and 1.0.0.2... now i want to route 200.100.25.100 and 200.10.50.100 usin rip.. i enable rip in both the routers... but whn i give the command show ip route... i jus get this Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS level-2, ia - IS-IS inter area * - candidate default, U - per-user static route, o - ODR P - periodic downloaded static route Gateway of last resort is not set A# so can sombody tell me where i hav gone wrong... thanku
How the STP determinw that which Port should be Root Port, which port should be Designeted Port , Blocking Port and Forwarding Port in Layer 2 STP topology
7 Answers Tech Mahindra, Wipro,
Explain how many maximum paths you can give on latest ios in rip?
Which statement about Ethernet networks is true? A. The advantage of a full duplex is the ability to transmit data over 111 cable B. Full duplex Ethernet requires a point-to-point connection when only two nodes are present C. Ethernet switches can use full duplex mode to connect multiple nodes to a single pod of a switch D. Half duplex is a cut through packet processing method that is vow fast little error correction Full duplex is a store and forward method that is slower but has better error correction
After how long ospf exchange its topology table?
What is window in networking terms?
In regards to the ISDN BRI standard, which channel is used for control? A.) B B.) D C.) E D.) I E.) Q
What is the difference between the communication and transmission?
CCNA 
