Answer / lakshmi

b

Answer / guest

Answer: A

What is the default LMI type for Cisco Routers that are using Frame-Relay? A.) Annex D B.) Q933A C.) Cisco D.) IETF E.) ARPA F.) Anex A

2 Answers  

---

IP RIP routing is conferred on a router but not all interfaces attach to RIP networks. What should you use to prevent all RIP routing updates from being sent through selecedc interfaces without using access lists? A. passive route B. default routes C. passive interface D. route update filtering

2 Answers  

---

Describe End to End network services: (Choose all that apply) A.) Best Route selection B.) Accomplished Segment by Segment, each segment is autonomous C.) Flow Control & Data Integrity D.) Best efforts packet delivery

1 Answers  

---

What is the utility of ping?

0 Answers  

---

In the setup dialog, what do the square brackets indicate? A. current or default spores B. hard coded values that cannot be modified C. values entered by the administrator but not saved D. values that must be written to PAVRAM before becoming enabled

1 Answers  

---

---

What is the Broadcast MAC Address?

3 Answers   Avaya, Cisco,

---

Identify the command to display the hardware platform information? A.) show all B.) show platform C.) display hardware D.) show version

1 Answers  

---

When using access lists, what does a Cisco router check first? A. To see if the packet is routable or bridgeable B. The destination address C. The source address D. The packet contents

1 Answers  

---

Hi -All Can you tell me About of NAt (Network Address Tranlator) bcoz i have no idea about this topics Such as local ip , global ip and all plz provide the deatil of this topics

3 Answers  

---

What is true when using DDR? A.) HDLC is the preferred encapsulation B.) You must use static routing C.) You should use dynamic routing D.) You should use ISDN

1 Answers  

---

What is the purpose of the DLCI? A.) Identifies the remote routers B.) Contained with a 802.2 frame for routing purposes C.) Used with PPP during authentication D.) Identifies the PVC in a Frame Relay network

1 Answers  

---

What is a backoff on an 802.3 networks A. It is latency in store and forward switching B. It is the time used for token passing from machine to machine C. It is the retransmission delay that is enforced when a collision occurs D. it is the result of two nodes transmitting at the same time. The frames from each transmitting device collide and are damaged.

3 Answers  

---