Interested to Buy Any Domain ? << Click Here >> for more details...
Which command will display the current time on a Cisco router?
A.) show date
B.) show clock
C.) show running-configuration
D.) show time
E.) show controllers
- 2 Answers
- 34857 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
A router on one side of a PPP link uses the resonance RTR1 and the password COPP1-PWD. Which configuration line on RTR1 enables a connection between RTR1 and another router named RTR2? A. username, RTR2 password COPR1-PWD, B. username, RTR1 password COPR1-PWD, C. username, RTR2 password COPR2-PWD, D. username, RTR1 password COPR2-PWD,
What is the difference between RIP & RIPng???? Can anyone explain it..!!! Thank u in advance.
What will transport layer do when data coming from session layer. They asked about intial operation(3 - way handshake)
srry for inconvnce ..here is complete qs...ignore the previous 1 3 router configured with RIP & Ripv2 rotuer 1- connected with router 2 having sr ip 10.0.1.2 routing : ripv2 E0:192.168.1.10 router 2: connected with router 1 and router 3 having sr 0 ip 10.0.1.3 & sr 1 ip 11.0.1.2 routing :rip & ripv2 E0=192.168.10.2 router 3: connected with router 2 having sr ip 11.0.1.3 routing: rip E0=172.16.10.2 is there communication possible?
what is frame relay?
Identify the correct IGRP configuration? A.) Router# router igrp 100 Router# network 10.0.0.0 B.) Router(config)# router igrp 100 Router(config-router)# network 10.0.0.0 C.) Router(config)# router igrp Router(config-router)# network 10.0.0.0
Identify the 3 key features of the Cisco Discovery Protocol? A.) Off by default B.) Will allow for the discovery of layer 3 addresses on neighbor routers C.) Verify connectivity D.) Open standard E.) Does not require any layer 3 protocols to be configured
Identify the purpose of the TCP 3 step handshake? A.) Setup a un-reliable connection B.) Initialize routing tables C.) Synchronize sequence numbers between hosts D.) Connection tear down process
WHY DO WE USE the command interface Vlan 1 ip adress x.x.x.x sub mask what does it do .. what does it create.. i know when we create it we can remotely telnet inti a router=switch. but what is the diff bwt vlan and intface vlan. ... vlan 1 bieng a native vlan remains there eve if i dont gv switch an ip address .. lease suggest.
What does the "IPX maximum-paths 2" command accomplish? A. It enables load sharing on 2 paths if the paths are equal metric paths. B. It sets up routing to go to network 2. C. It is the default for Cisco IPX load sharing. D. It enables load sharing on 2 paths if the paths are unequal metric paths.
What is the difference between switch and hub?
Which peer authentication method and which ipsec mode is used to connect to the branch locations? (Choose two)
CCNA 
