Which two describe frame tagging? A.) Examines particular info about each frame B.) A unique ID placed in the header of each frame as it traverses the switch fabric C.) A user- assigned ID defined to each frame D.) The building of filter tables

1 Answers  

---

If you are in IOS user mode, which command do you use to enter the privileged mode? A. Set B. Enable C. Configure D. Privileges

2 Answers  

---

Identify the default values that make up IGRP's composite metric? A.) Bandwidth B.) Load C.) Reliability D.) MTU E.) Delay

1 Answers  

---

Which two does 100BaseT use? A.) CSMA/CD B.) IEEE 802.5 C.) 802.3u D.) Switching with 53-byte cells

3 Answers  

---

Which two statements about integrated services digital network (ISDN) are true? A. ISDN provides data only capability B. ISDN provides an integrated voice/data capability C. The ISDN standards define the hardware and call setup schemes for end the end digital connectivity D. Users receive more bandwidth on WANS with a leased lin of 56 Cops than with multiple B channels

1 Answers  

---

wat is last assignable host address in 209.165.201.0/27 network?

7 Answers  

---

What does a Standard IP Access-list use as test criteria? A.) IP source address B.) IP source and destination address, protocol numbers and port numbers C.) IPX source and destination address D.) Source MAC address

1 Answers  

---

What do the following commands accomplish? access-list 1 deny 172.16.4.0 0.0.0.255 access-list 1 permit any interface ethernet 0 IP access-group 1 out A. This will block traffic from subnet 172.16.4.0 and allow all other traffic. B. This will allow traffic from subnet 172.16.4.0 and block all other traffic. C. All traffic is allowed. D. All traffic is blocked.

1 Answers  

---

Which type of routing you did in ccna?

0 Answers  

---

Which layer is responsible for determining if sufficient resources for the intended communication exists? A.) Application B.) Network C.) Session D.) Presentation E.) Transport

1 Answers  

---

Which protocol works only on cisco routers?

0 Answers  

---

Identify the command to determine if CDP is enabled? A.) show enable cdp B.) show cdp enabled C.) show cdp run D.) show cdp

1 Answers  

---