Which protocol works only on cisco routers?


No Answer is Posted For this Question
Be the First to Post Answer

Post New Answer

More CCNA Interview Questions

IP extended access lists use which of the following as a basis for permitting or denying packets? A.) destination address B.) all of the above C.) protocol D.) source address E.) port

3 Answers  


In which three situations is a hold down timer reset? (Choose three) A. when the hold down timer expires B. when infinity is finally defined as some maximum number C. when the router exchanges update summaries at area borders D. when the router detects faulty LSPs propagating through the internetwork E. when another update is received indicating a new route with a better metric F. when another update is received indicaing the original route to the network has been restored G. when the router receives a processing task proportional to the number of links in the internetwork

1 Answers  


How to see the running-config & startup-config infor from global configuration mode. As we know, from priviledge mode we cn see it by executing command. i.e. Router#show running-config and Router#show startup-config Now wat is the coommands use in global configuration mode o see those info. Router(Config)# ??????

4 Answers   Juniper Networks,


What is the beaconing?

0 Answers  


Tell me which cable we connect in db-9?

0 Answers  






How many broadcast domains are in switch?

0 Answers  


What are hold-downs used for? A.) To prevent regular update messages from reinstating a route that has come back up B.) Information received on an interface cannot be sent back out the same interface C.) To prevent regular update messages from reinstating a route that has gone down D.) To hold the routing table from being sent to another router

1 Answers  


Can you define in short what VPN is?

5 Answers   CCIE,


Define ios?

0 Answers  


Identify the number range for IPX SAP filters? A.) 900 - 999 B.) 1000 - 1099 C.) 800 -899 D.) 100 - 199

1 Answers  


Identify 2 reasons for disabling CDP? A.) If the router is not configured for RIP B.) Save bandwidth by eliminating overhead C.) If the router is configured for Appletalk D.) When connected to a non-Cisco router

1 Answers  


What is the syntax to use to configure the port on a Catalyst 5000 switch? A.) slot port/type B.) type slot/port C.) port slot/type D.) port type/slot

1 Answers  


Categories