Golgappa.net | Golgappa.org | BagIndia.net | BodyIndia.Com | CabIndia.net | CarsBikes.net | CarsBikes.org | CashIndia.net | ConsumerIndia.net | CookingIndia.net | DataIndia.net | DealIndia.net | EmailIndia.net | FirstTablet.com | FirstTourist.com | ForsaleIndia.net | IndiaBody.Com | IndiaCab.net | IndiaCash.net | IndiaModel.net | KidForum.net | OfficeIndia.net | PaysIndia.com | RestaurantIndia.net | RestaurantsIndia.net | SaleForum.net | SellForum.net | SoldIndia.com | StarIndia.net | TomatoCab.com | TomatoCabs.com | TownIndia.com
Interested to Buy Any Domain ? << Click Here >> for more details...


Identify the command that will display the RIP routes
entering and

leaving the router?

A.) Router(config)# debug ip rip

B.) Router# debug ip rip

C.) Router>debug ip rip

D.) Router# debug rip routes



Identify the command that will display the RIP routes entering and leaving the router? A.) Ro..

Answer / guest

Answer: B

Is This Answer Correct ?    3 Yes 1 No

Post New Answer

More CCNA Interview Questions

Identify 2 HDLC characteristics? A.) Default serial encapsulation B.) Open standard C.) Supports Stacker compression D.) Supports point-to-point and multipoint

1 Answers  


Identify the command to copy a configuration file from a TFTP server to a routers active configuration? A.) Router# copy running-config tftp B.) Router# copy tftp running-config C.) Router# copy tftp 172.16.0.1 running-config D.) Router(config)# copy tftp running-config

3 Answers  


Using the access-list command, 'access-list 1 deny 2.2.2.2', what else must be done to stop host 2.2.2.2 from sending any traffic out of physical interface E0, while still allowing other traffic? A.) In global mode, Add a line - 'access-list 1 permit 0.0.0.0 255.255.255.255' B.) On interface E0, Add a line - 'access-group 1 in' C.) In global mode, Add a line - 'access-list 1 permit all' D.) On interface E0, Add a line - 'access-list 1 in' E.) On interface E0, Add a line - 'access-list 1 out' F.) On interface E0, Add a line - 'ip access-group 1'

1 Answers  


Which of the following is a connectionless protocol at the Transport layer? A.) UDP B.) ARP C.) ICMP D.) RARP E.) IP F.) FTP

4 Answers  


What is the minimum and maximum request timer?

0 Answers  


Can you define in short what VPN is?

5 Answers   CCIE,


What is the terminal emulation?

0 Answers  


what is eigrp and what is the benfit of eigrp over igrp what is route summryization if one the router route is not showing the what should be problem how to resolve these problem what is fessible suceer. is the load balncing is one of the property of eigrp what is the metihod of authantication what is the diffrnec betwee pap and chap what is stp command for enabling stp and rstp why switching loop occur what is the main factor of ocuring switch loop what is the mechnaism for stoping the roting loop what is best diffrence betwwen ospf v1 nad ospf v2 what is vtp what is the diffrence between vtp version 1 and veron 2 what is the ip address what is the diffrence betwwen ip address mac address what is dhcp and how it work what is 3 way hand shake what is the difrence betwwen network id and brodcast id what is the network id for 111.111.111.10/29 what is the command for enabling vlan on 3650 csco switch

1 Answers   HCL, Microland,


I have layer 3 Cisco 3560(Multilayer) switch right.How we can configure sub interface & Inter VLAN(we have vlan 2,3 & 10 ),Each VLan talk with each other?

4 Answers   IBM,


Identify the default values that make up IGRP's composite metric? A.) Bandwidth B.) Load C.) Reliability D.) MTU E.) Delay

1 Answers  


Can 2 different VTP Domain Communicate. if yes then How.

7 Answers  


whats the routing protocol supporting in both juniper , cisco routers.

10 Answers   HCL,


Categories