What is the minimum and maximum request timer?
- 1 Answers
- 1316 Views
- I also Faced
- E-Mail Answers
Answer / Satyam Srivastava
In TCP (Transmission Control Protocol), the minimum request timer is typically 500 milliseconds, but it can be configured differently based on network conditions. The maximum request timer is often set to 2 minutes (120 seconds).
| Is This Answer Correct ? | 0 Yes | 0 No |
Which command displays the intenances using a given access list? A. show filters B. show ip interface C. show active lists D. show interface paramaters E. configure ip access lists F. show access-list interfaces
friends i have some problem in the acess list plz help me out. purbi sinha. 1 what is the diffrence b/w inbound and out bound access list 2 what is main diffrence betwwen standred acesslist and extended access list 3 where should i keep stnadred access list and exatended access list i mean at which interface and why? 4 why wild card masking is used 5 what is switch febric in switching plz help me out i am litle bit confuse
How we put NIC in promiscuous mode when using MS windows, can any one tell me in detail
Which of the following statements is false? If your Frame Relay link does not support inverse ARP, you must manually map DLCIs to network Address. One of the major advantages of Frame Relay is its ability to connect to multiple PVCs using only one physical link. DLCI addresses are determined by the network administrator when installing the network. Which of the following statements is false? If your Frame Relay link does not support inverse ARP, you must manually map DLCIs to network Address. One of the major advantages of Frame Relay is its ability to connect to multiple PVCs using only one physical link. DLCI addresses are determined by the network administrator when installing the network. In order for two ends of virtual circuits to communicate using Frame Relay, their network addresses must be mapped to DLCIs.
Which of the following provide connection-oriented transport to upper layer protocols? A.) SPX B.) RIP C.) NLSP D.) NCP
Which global configuration command will tell the router to load the IOS file 'IOS_filename' from FLASH memory at the next boot? A.) boot system flash B.) boot system flash IOS_filename C.) boot system IOS_filename flash D.) boot system tftp IOS_filename tftp_address E.) config-register 0x0102 IOS_ filename
what is the difference between osi and tcp ?
What does data packets consist of?
When you type google.com what are the process involved from layer 7-layer1?
How many types of IP routings?
14 Answers CK, TCS,
Identify 3 characteristics of ISDN? A.) Transports voice and data B.) Transports voice only C.) Support both BRI and PRI D.) Runs over existing phone lines E.) Same as X.25
What utility can you use to see the path a packet takes through an internetwork? A.) Route B.) SNMP C.) Trace D.) Ping
CCNA 
