Interested to Buy Any Domain ? << Click Here >> for more details...
Which of the following is a connectionless protocol at the
Transport layer?
A.) UDP
B.) ARP
C.) ICMP
D.) RARP
E.) IP
F.) FTP
- 4 Answers
- 11164 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / nasriza
E.) IP
don't forget check out http://nasriza.blogdetik.com/
| Is This Answer Correct ? | 0 Yes | 7 No |
Explain what is overlaod?
How many valid ip will b in /21 in route summarization?
Identify the command mode necessary to enter the extended ping command? A.) Router# B.) Router> C.) Router(config)# D.) Router(ext-ping)#
Can you explain the broader steps of how L2F establishes the tunnel?
What must be true for two routers running IGRP to communicate their routes? A.) Same autonomous system number B.) Connected using Ethernet only C.) Use composite metric D.) Configured for PPP
What is 100BaseFX?
What is the difference between ‘bit rate’ and ‘baud rate’?
What is difference between IPv4 & IPv6??
Which command will show you if you have a DTE or DCE cable connected to an interface?
Suppose a USER is saying he is not able to access the internet or page loading is slow what trobleshooting steps you will take to get it fixed
Identify 3 characteristics of an IP address? A.) Contains a network portion and a host portion B.) 32 bits long C.) Unique to each network D.) Part of the default Cisco configuration E.) Referred to as the hardware address
From Enable mode, a user types the letter 'C' and presses enter. There is more than 1 command that starts with 'C'. What message would the router return? A.) Nothing would be returned, the command is simply ignored. B.) unknown command C.) ambiguous command. D.) Copy to? E.) Configured console from console.
CCNA 
