Identify the command mode necessary to enter the standard ping
command?
A.) Router(config)#
B.) Router>
C.) Router(std-ping)#
D.) Router(config-if)#
- 1 Answers
- 4419 Views
- I also Faced
- E-Mail Answers
Identify the order of the 5 step encapsulation? 1) Create the segment 2) Convert the frame to bits 3) Create the packet 4) Create the frame 5) User creates the data A.) 1,2,4,2,5 B.) 2,1,3,4,5 C.) 5,1,3,4,2 D.) 5,3,4,1,2
Which two statements accurately define IP addressing rules? (Choose two) A. IP multicast addresses start with 240 B. A host Carbon of all 1 a indicates a network broadcast C. The value of zero (0) in the host Carbon means all hosts on the network D. IP addresses are four octets long and contain a network Carbon and a host Carbon
Define bandwidth?
Default packet size of ipv6?
What is the difference between rip and igrp?
What are the different memories that are used in a cisco router?
Which statement about the Point to Point Protocol (PPP) is true? A. PPP supports TCP/IP but not Novell IPX B. PPP is being phased out of existence by the Serial Line Internet Protocol (SLIP) C. PPP providces router to router and host to network connections over both synchronous and asynchronous circuits D. PPP is an ITU T and ANSI standard that defines the process for sending data over a packet switched data network (PSDN)
IGRP supports a feature that allows traffic to be distributed among up to 6 (4 default) paths to provide greater overall throughput and reliability. What is this called? A. unequal-cost load balancing B. equal-cost load balancing C. proportionate load balancing D. low cost load balancing
What is Standard ACLs?
What are the disadvantages of symmetric algorithms?
Identify the definition of demarcation? A.) Date in which the WAN service contract expires B.) Cabling which extends from the WAN service provider to the customer C.) Division of responsibility, where the CPE ends and the local loop begins D.) Equipment which is located at the customer premises
Identify the command that forces the router to load into ROM mode upon a reload? A.) boot system rom B.) rom boot C.) boot system flash rom D.) boot router rom
CCNA 
