Interested to Buy Any Domain ? << Click Here >> for more details...
What command do you use to disable domain lookup?
A.) no domain-lookup
B.) domain no-lookup
C.) lookup no-domain
D.) no ip domain-lookup
- 2 Answers
- 11945 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
What is the difference between ‘bit rate’ and ‘baud rate’?
hi friend i am stuck in the big problem.this problem is regading pix firewall. i have a cisco pix 515e firewall inmy company.now when i configure it and after rebooting it the ACT link never getup.when i apply clear config all comand the ACT link get up after oveservation i see that there is fauilover problem when i apply failover active ACT link agin get up is there any way to get my firewall in standby mode rember that there is only on firewall within my n/w i am lookig towards all of you jitendera kumar sinha
What is the protocol number for UDP? A.) 6 B.) 17 C.) 25 D.) 21
Identify 3 ways in which a router can be configured? A.) TFTP B.) Nvram C.) Ping D.) Console E.) Trace
Which of the following use PVCs at layer 2? A.) X.25 B.) HDLC C.) Frame relay D.) ISDN
How many types of ips?
Which command would show all Ethernet interfaces with IPX configured on them? A.) show interface ipx ethernet B.) show ipx interface C.) show ipx interface ethernet D.) show ipx E.) show version F.) show run
Explain the term 'multicast'.
What is the difference between static ip addressing and dynamic ip addressing?
What is default packet size of ipv6?
Which ISDN protocol prefix specifies switching and signaling? A.) I B.) E C.) Q D.) S
If you have configured IPX on a Serial interface, which command would display the IPX network and node address on the Serial 1 interface? A.) show interface B.) show ipx s1 C.) show interface s1 D.) show ipx int serial 1 E.) show ipx int brief
CCNA 
