Identify the command mode necessary to enter the extended ping

command?

A.) Router#

B.) Router>

C.) Router(config)#

D.) Router(ext-ping)#

Answers were Sorted based on User's Feedback



Identify the command mode necessary to enter the extended ping command? A.) Router# B.) Rou..

Answer / guest

Answer: A

Is This Answer Correct ?    5 Yes 0 No

Identify the command mode necessary to enter the extended ping command? A.) Router# B.) Rou..

Answer / guest

A,B

Is This Answer Correct ?    2 Yes 2 No

Identify the command mode necessary to enter the extended ping command? A.) Router# B.) Rou..

Answer / arun

c router (config)#

Is This Answer Correct ?    0 Yes 3 No

Post New Answer

More CCNA Interview Questions

Which ISDN specification series deals with Concepts and Terminology? A.) C- Series B.) I- Series C.) Q-Series D.) 911-Series E.) J-Series F.) F-Series

1 Answers  


Which of the following are characteristics of UDP? A.) UDP is connection oriented. B.) UDP is used with TFTP. C.) UDP is unreliable. D.) UDP is connectionless. E.) UDP is at the transport layer. F.) UDP uses no acknowledgements.

6 Answers  


What is loop back ip in ipv6?

0 Answers  


Given the address 172.16.2.120 and the subnet mask of 255.255.255.0. How many hosts are available? A. 254 B. 510 C. 126 D. 16,372

1 Answers  


what is vtp there is three question regatding vpn but i know it is not conserned with that

3 Answers   IBM,






What is the subnet? Why is it used?

0 Answers  


how many vlan can be configured on a single switch

12 Answers   IBM, Sigma IT,


Why we using Tcp/IP. Why we can't use just Tcp ip? What is the meaning of '/' symbol in between this?

5 Answers  


You need to come up with a TCP/IP addressing scheme for your company. Which two factors must you consider when you define the subnet mask for the network? A.) The location of DHCP servers B.) The volume of traffic on each subnet C.) The number of subnets on the network D.) The location of the default gateway E.) The number of host IDs on each subnet

1 Answers  


Name the 2 protocols are in wan technology?

0 Answers  


How does a switch use store and forward? A.) By using a Class I repeater in a collision domain B.) The LAN switch copies the entire frame into its onboard buffers and then looks up the destination address in its forwarding, or switching, table and determines the outgoing interface C.) By using broadcast addresses as source addresses D.) The switch waits only for the header to be received before it checks the destination address and starts forwarding the packets

1 Answers  


there is three mode of vtp let there are three switch s1 in server mode s2 in transparent mede and s3 in clint mode then will that tranparnt mode going to effect the network if yes then how and if no then what it will do

2 Answers   IBM,


Categories