Port selection is done at which layer of OSI reference
model?????
- 4 Answers
- 6716 Views
- I also Faced
- E-Mail Answers
Answers were Sorted based on User's Feedback
Answer / sohan
port slection is based act on transport layer basicaly but
some cases it is n/w layer
| Is This Answer Correct ? | 6 Yes | 3 No |
Answer / jitendera kumar
hi sahin it is depend upon which type of protcol u r
using .so it is total depenf upon your protocol
| Is This Answer Correct ? | 0 Yes | 0 No |
what is LAPB
What is the point-to-point protocol in ccna?
The ICMP (referred to in RFC 1700) is implented by all TCP/IP hosts. A. true B. false
Which layer called error detection layer?
Hello every one. Please can any one explain me the difference b/w Cisco Switch/ws-c3560-24ps-s and Switch/ws- c3560-24ts-s. what is does PS & TS Stands for. Waiting for your passtive reply. Wish You all the best
what the exact definition of Ethernet.plz reply as soon soon as possible
Identify the command to display the Frame Relay map table? A.) Router# display frame-relay map B.) Router# show frame-relay map C.) Router(setup)# show frame-relay map D.) Router# show map frame-relay
How do you find the parameters that you can use with the SHOW command? A.) ? show B.) show ? C.) debug show D.) help E.) sh?
Identify the command to configure the router to boot from an alternate IOS located in flash? A.) boot system flash IOS.exe B.) boot system tftp IOS.exe 172.16.5.1 C.) boot system alternate IOS.exe D.) boot system rom IOS.exe
Explain the difference between igp and eigrp?
What is the most common layer 2 device? A. Hub B. Bridge C. Switch D. Router
What is the second best path name of eigrp?
CCNA 
