Identify the command to determine if CDP is enabled?
A.) show enable cdp
B.) show cdp enabled
C.) show cdp run
D.) show cdp
Answers were Sorted based on User's Feedback
What port does rip use?
How much hold down time of eigrep protocol?
How broadcast is created in switch
Tell me which protocol called rapid protocol?
The Internet Protocol (IP) occurs at what layer of the seven layer model? A.) Physical B.) Presentation C.) Network D.) Datalink E.) Session F.) Transport
Which technology is used by Catalyst switches to resolve topology loops and ensure data flows properly through a single network path? A. virtual LANS (VLANS) B. frame filtering C. cut-through switching D. spanning-tree protocol
Which two commands allow you to verify address configuration in your unternetword? (Choose two) A. ping B. trace C. verify D. test ip E. Echo ip F. config ip
Identify the command to reload the router? A.) Router(config)# reload B.) Router# reset C.) Router# reload D.) Router> reload
Which is true regarding store-and-forward switching method? A.) Latency varies depending on frame-length B.) Latency is constant C.) It is default for all Cisco switches D.) It only reads the destination hardware address before forwarding the frame
Which of the following would not be displayed by the command ?sho cdp neighbor detail?? A.) The incoming/outgoing interface. B.) The hardware platform. C.) One address per protocol. D.) Amount of Flash Memory Available E.) The routers hostname. F.) The subnet mask, if IP is configured.
You are given the following address: 15.16.193.6/21. Determine the subnet mask, address class, subnet address, and broadcast address. A. 255.255.248.0, A, 15.16.192.0, 15.16.199.255 B. 255.255.248.0, B, 15.16.192.0, 15.16.199.255 C. 255.255.248.0, A, 15.16.199.255, 14.15.192.0 D. 255.255.242.0, A, 15.16.192.0, 15.16.199.255
Identify the default encapsulation on serial interfaces? A.) ISDN B.) HDLC C.) SDLC D.) Frame Relay E.) PPP