Answer / avinash

A

Answer / mohsin baloch

its A

Answer / guest

Answer: C

In the setup dialog, what do the square brackets indicate? A. current or default spores B. hard coded values that cannot be modified C. values entered by the administrator but not saved D. values that must be written to NVRAM before becoming enabled

1 Answers  

---

Novell NetWare has an Ethernet frame type called Ethernet_II. What is the matching Cisco command line keyword for this encapsulation method? A.) dix B.) sap C.) arpa D.) gns E.) snap F.) novell-ether

1 Answers  

---

Which of the following can reply to a Novell Get Nearest Server (GNS) request? A.) Local Novell server B.) Remote Novell Printer C.) Cisco router D.) Novell client

1 Answers  

---

the term which used for describe physical alyout of network mine answer-topology

1 Answers  

---

Of the following switching types, which one has the highest latency? A.) Cut-through B.) None C.) Store-and-forward D.) Fragment Free

1 Answers  

---

What does a router change in a packet when it forwards a packet to the next hop? * A: Destination physical address * B: Destination network address * C: Destination network address and the destination physical address

10 Answers   Microland,

---

Which layer is responsible for negotiating data transfer syntax? A.) Network B.) Session C.) Application D.) Transport E.) Presentation

2 Answers  

---

Which of the following are Distant Vector protocols? A.) IGRP B.) RIP C.) OSFP D.) EIGRP

1 Answers  

---

Hi Jitendera, I continuously read your answers which is more knowlegable than books... Q.I am facing some problems in subnetting.can you plzz explain the subnetting process.. will be remain thankful

4 Answers  

---

Hi, I am littl bit confused about ip Addressing scheme? can someone tell me how can we assign ip addresses to pc

2 Answers  

---

Identify the keystroke used to terminate the setup mode? A.) Ctrl-K B.) Crtl-C C.) Ctrl-Z D.) Crtl-End

2 Answers  

---

I am facing one problem in my layer 2 switch I don’t know the problem is on switch side or client side. The problem is some PC (not all) are stop participate in LAN they don’t send or recd. Packet from switch and if I check RJ45 (with LAN tester)from PC side the packet and 8 pin wire is working fine and after that process of LAN tester I plug RJ 45 in PC now PC start recd/ send packets what is the problem I don’t understand even client side no virus found RJ45 is ok and switch has no problem bcoz other PC is working fine Cable (cat 5 ) is also fine bcoz I didn’t crimp again just check in LAN tester and start working fine. Plz any one solve this matter. And after lan tester process pc is working fine and after 2 or 3 hour it again start same problem and again same process lan tester I have used

5 Answers  

---