Which statement about Ethernet switches is true?

A. Symmetric switching allows connection between pods of
unlike bandwidth and does not require memory buffering

B. Memory Buffering is used to prevent a bottleneck when
pods of different bandwidth are connected on a symmetric switch

C. The latency can be reduced if the switch utilizes the
store and forward method of switching store and forward is
better for error detection

D. The cut through method of switching is faster because the
switch forwards the packet to the destination as soon as it
reads the destination address



Which statement about Ethernet switches is true? A. Symmetric switching allows connection between..

Answer / guest

Answer: D

Is This Answer Correct ?    2 Yes 0 No

Post New Answer

More CCNA Interview Questions

Identify the 2 commands that copies the configuration in NVRAM to RAM? A.) copy backup-config running-config B.) configure nvram C.) copy startup-config running-config D.) configure memory

2 Answers  


Identify the administrative distance and appropriate routing protocol? A.) RIP = 255, IGRP = 100 B.) RIP = 100, IGRP = 120 C.) RIP = 1, IGRP = 0 D.) RIP = 120, IGRP = 100

3 Answers  


How many networks route update does a router recieves in RIP at once ?

3 Answers   ComNet,


In IOS boot sequence if the flash is erased, and there is no access to TFTP server, and we can't load the partial IOS from ROM. Is there any possiblity that we can still boot the router/switch from external PC in which the IOS is installed?

6 Answers  


After the command -- router igrp 200 -- what command would enable IGRP on the router for interface E0, with an address of 157.89.4.4 and a mask of 255.255.255.0 ? A.) network 157.89.4.0 255.255.255.1 B.) network 157.89.0.0 C.) router igrp * D.) router igrp 157.89.0.1 E.) router igrp int e1 F.) router igrp 157.89.4.1

2 Answers  






What is mtu and what is its size for transmission?

0 Answers  


Identify 2 PPP characteristics? A.) Is proprietary to Cisco B.) Supports authentication C.) Support compression D.) Run on a multi-access network

1 Answers  


what is the difference between dynamic NAT and NAT overload ? and how it works ?

4 Answers  


What does -1 mean in an extended IPX access-list? A.) Any IP address B.) Deny all C.) Deny host D.) Any host or any network

1 Answers  


What is the frame relay, in which layer it comes?

0 Answers  


How much hold down time of eigrep protocol?

0 Answers  


Can yo define LNS

0 Answers   CCIE,


Categories