Answer / sasan

good

How many subnets can be gained by subnetting 172.17.32.0/23 into a /27 mask, and how many usable host addresses will there be per subnet?

11 Answers   SITTC,

---

Define the virtual channel?

0 Answers  

---

Identify the command that forces the router to load into ROM mode upon a reload? A.) boot system rom B.) rom boot C.) boot system flash rom D.) boot router rom

1 Answers  

---

Repeaters work at which layer of the OSI model? A.) Network B.) Session C.) Transport D.) Physical

6 Answers   Wipro,

---

When using access lists, it is important where those access lists are placed. Which statement best describes access list placement? A. Put standard access lists as near the destination as possible. Put extended access lists as close to the source as possible. B. Put extended access lists as near the destination as possible. Put standard access lists as close to the source as possible. C. It isn't import where access lists are placed since the router will read and cache the whole list. D. Put access lists as close to corporate headquarters as possible.

1 Answers  

---

What must you do to test connectivity on a dial on demand routing (DDR) link? A. increase the idle Import parameter B. send interesting traffic across the link C. reboot one of the integrated services digital network (ISDN) routers D. reset the DDR integrated services digital network (ISDN) router statistics to zero

1 Answers   HCL, IACM,

---

What is the command for change serial cost?

0 Answers  

---

What is Phase od VPN in site to site and what information you will require to configure a SITE to SITE VPN

0 Answers   Infosys,

---

If i had 400 computers set in a site how many VLAN i should configure so that i can share a proper bandwith,and also i had two lease line connection of 2Mbps each,

1 Answers   IBM,

---

Which statements are true regarding half duplex? A.) Only works in a point-to-point configuration B.) Allows for transmitting and receiving but not at the same time C.) Allow for transmitting and receiving of data simultaneously D.) Doubles the bandwidth

2 Answers  

---

take a pen and copy before solving that question there is a router name Ra there is two switch sw1 and sw2 sw1 is coneceted through fa0/1 interface of router Ra sw2 is conected through the fa1/1 serai interface of router s0/1 conected through the isp with it ip address 192.168.1.1 now therer are three host conexted through the sw1 and having ip host1=10.1.2.1 host2=10.1.2.2 host3=10.1.2.3 now there is also 3ree host conected through switch 2 i.e sw2 having ip host4=10.1.1.1 host 5=10.1.1.2 host 6=10.1.1.3 now i think u have made corect confrigation.now questios is started network admin configure the Ra router in that fassion Ra(config)#access-list 2 permit 10.1.1.0 0.0.0.255 Ra(config)#line vty 0 4 ra(config)#access-class 2 in now question is that why should network admnistratoe do it in this maneer A to give access sw1 host to acess internet B to prevent sw1 host from acessing comand promt c to prevent sw2 host from accessing console of router ra D to give sw2 host access to the enternet e prevent sw1 host from accessing internet f to prevent sw1 host from acessing the sw2 host network isp------(s0/1)..RA..(fa1/1)---SW2-host (4,5,6) | | (sw1)------host 1,2,3 this is not exect digarm but help to derive the diagram plz answer as soon as possible

6 Answers   AT&T,

---

what is difference between hub and router.....

5 Answers   Thomson,

---