Which command loads a new version of the Cisco IOS into a router? A. copy flash ftp B. copy ftp flash C. copy flash tftp D. copy tftp flash

2 Answers  

---

How does inter- VLAN communication take place? A. It takes place through any Cisco router B. It takes place through a Cisco router that can run ISL C. It takes place through a router but this disables all the router a security and filtering functionality for the VLANS D. For nonroutable protocals (e.g. NetBeui) the router provides communications between VLAN domains E. Inter-VLAN communication is not possible because each VLAN is a separate broadcast domain

3 Answers  

---

The Datalink layer works with which of the following: A.) Packets B.) Bits C.) Globules D.) Frames E.) Segments

2 Answers  

---

Can anyone explain in details the STP port state?????

2 Answers  

---

You have powered on a new router and you want to create an initial configuration. Which mode should you use? A. copy mode B. user mode C. setup mode D. startup mode

4 Answers   Enrich,

---

what is vtp there is three question regatding vpn but i know it is not conserned with that

3 Answers   IBM,

---

What is the protocol number for UDP? A.) 6 B.) 17 C.) 25 D.) 21

1 Answers  

---

What’s the simplest way to remotely configure a router?

0 Answers  

---

Can you explain voluntary and compulsory tunnels?

0 Answers   CCIE,

---

What 3 sources can configuration commands be placed into RAM? A.) HP Openview B.) Console C.) Vterminal D.) TFTP server E.) NVRAM

1 Answers  

---

Hello Mr.Jitendera Kuamr Sinha, how is every thing going on? Thanks for your reply. Dear Friend if you can Explain it little bit deeper i will be realy thanks full. Wish you all the Best.

1 Answers  

---

HI friends mine one of the friends have ask a good question i also donot know the answer so i am putting here Please poet the answer no matter it is wright or wrong put yours view here The question is like that when we are going to configure ospf then there are three way 1st way router ospf 10 netwrok 192.168.1.0 0.0.0.255 area 0 network 192.168.2.0 0.0.0.255 area 0 the 2nd way is like that router ospf 10 netwrok 192.168.0.0 0.0.255.255 area 0 but he inrodused the thrird way like router ospf 10 netwrok 192.168.00000001.0 < ?.?.?.?>area 0 router ospf 10 netwrok 192.168.00000010 <?.?.?.?>area 0 now problem is that what should i put the mask in this way so i puted ? sign Please solve this problem i think this is good one plz donot see for answer please contribute any thing i am reqesting Than you Jitendera kuamr sinha

5 Answers  

---