Identify the OSI layer which is responsible for end-to-end
connections?
A.) Network
B.) Transport
C.) Session
D.) Data link
E.) TCP
Answers were Sorted based on User's Feedback
Answer / guest
Answer: B
Layer 4 is the Transport layer and is responsible for end-to-end
connections.
Is This Answer Correct ? | 30 Yes | 3 No |
What is the default routing metric used by IGRP? A.) MTU, delay, bandwidth, reliability, and loading B.) Count to infinity C.) Bandwidth and delay D.) Hop count
Which port numbers are used by TCP and UDP to set up sessions with other hosts? A.) 1024 and above B.) 6 and 17 respectively C.) 1-25 D.) 6-17
Which routing protocols uses connection-oriented routing updates? A.) IGRP B.) UDP C.) RIP D.) IP E.) BGP
What is the distance limitation for 100BaseT? A. 607 ft B. 25 Meters C. 1,000 ft D. 185 Meters
If configuring a Cisco router to connect to a non-Cisco router across a Frame Relay network, which encapsulation type would you select? A.) Q933a B.) ISDN C.) IETF D.) CISCO E.) ANSI
Define Poison Reverse? A.) To prevent regular update messages from reinstating a route that has gone down B.) Packets sent out that are not destined for a network go to the default network C.) Information received on an interface cannot be sent back out the same interface D.) When a network goes down, the router enters in its table the number 16 to signify destination unreachable
Identify the command to display the IP host table? A.) show ip hostnames B.) show ip names C.) show hosts D.) show ip hosts
Hi all, suppose more than two network administrators are configure same router with different configuration through telnet at the same time.. then whose(admin's) configuration will use router for routing ?
Tell me CCNA Course + Dump Q/A in chennai?
Identify the purpose of the following command 'ip route 192.168.100.0 255.255.255.0 10.1.0.1' A.) Enabling a dynamic routing protocol B.) Creating a static route to the 10.1.0.0 network C.) Teaches the router about the distant network 192.168.100.0 and how it can be reached via 10.1.0.1 D.) Assigining the IP address 192.168.100.0 to an interface
If a router uses dynamic routing, how does it learn the route to remote networks? The router uses a DHCP request to obtain remote network numbers. The router uses a routing protocol to exchange routing info. with other routers. The router uses DNS request packets to obtain remote network numbers. The Network Administrator manually configures the remote networks.
Explain what is the size of hello packets in eigrep protocol?