Interested to Buy Any Domain ? << Click Here >> for more details...
Which command will give the following output:
Tty Typ Tx/Rx A Modem Roty AccO AccI Uses Noise Overruns Int
* 0 CTY - - - - - 0 0 0/0 -
1 AUX 9600/9600 - - - - - 0 0 0/0 -
* 2 VTY - - - - - 2 0 0/0 -
3 VTY - - - - - 0 0 0/0 -
4 VTY - - - - - 0 0 0/0 -
5 VTY - - - - - 0 0 0/0 -
6 VTY - - - - - 0 0 0/0 -
- 1 Answers
- 4173 Views
- I also Faced
- E-Mail Answers
Answer / jitendera sinha
icanot get the answer after 10 visit
now i have the answer
answer is
router#show line(TRY On physical router not on boson)
| Is This Answer Correct ? | 0 Yes | 2 No |
what hapeen we we configure default root on the router which is conected by isp supoese there are two router r1 is conected throug isp and and by s0 r1 is conexted to r2 if we apply degault root on r1 what will happen
What do you use the Aux port for? A.) Console B.) Terminal editing C.) Modem D.) Backup logging
What is Transport and Tunnel mode?
What is the purpose of the DLCI? A.) Identifies the remote routers B.) Contained with a 802.2 frame for routing purposes C.) Used with PPP during authentication D.) Identifies the PVC in a Frame Relay network
Identify the keystroke to position the cursor to the beginning of a command line? A.) Ctrl-A B.) Ctrl-Ins C.) Ctrl-B D.) Ctrl-Z
What are the different memories that are used in a cisco router?
What is difference between fast ethernet and ethernet port?
13 Answers Bank of Baroda, Bank Of India,
What is the difference between csma/cd and csma/ca?
What is the difference between static and dynamic ip addressing?
Which command, that is used to test address configuration, uses Time-To-Live (TTL) values to generate messages from each router. A. trace B. ping C. telnet D. bootp
What layer can optionally support reliability? A.) Transport B.) IP C.) Physical D.) Network E.) Sub-physical layer
Which statement about the data link connection identifier (DLCI) is true? A. It is a number that identifies a local virtual circuit in a Frame Relay network B. It is a signaling standard between the CIDE device and the Frame Relay switch C. It is the clock speed (pod speed) of the connection (local loop) to the Frame Relay Cloud D. It is the Maximum number of uncommitted bits that the Frame Relay switch will attempt to transfer beyond the Committed Information Rate (CIP)
CCNA 
