You have a Frame Relay link on serial 1. Which command
displays the Local Management Interface (LMI) data link
connection identifier (DLCI) and bandwidth for that link?

A. show interface serial1

B. show frame-felay serial1

C. show protocol frame-relay serial1

D. show serial1 encapsulation frame-relay



You have a Frame Relay link on serial 1. Which command displays the Local Management Interface (LM..

Answer / guest

Answer: A

Is This Answer Correct ?    0 Yes 0 No

Post New Answer

More CCNA Interview Questions

Identify 3 features of IGRP? A.) Composite metric B.) New horizon C.) Flash (triggered) updates D.) 60-second periodic updates E.) Poison reverse

1 Answers  


What is window in networking terms?

1 Answers  


Which term describes the process in which frames from one network system are placed inside the frames of another network system? A. bridging B. tunnelling C. data link control D. generic routing E. packet switching

1 Answers  


Identify the command that saves the configuration stored in RAM to NVRAM? A.) copy running-config startup-config B.) copy tftp running-config C.) copy startup running D.) copy active to backup

1 Answers  


Tell us the name of algorithm of eigrp protocol?

1 Answers  


Identify the command to display the Frame Relay map table? A.) Router# display frame-relay map B.) Router# show frame-relay map C.) Router(setup)# show frame-relay map D.) Router# show map frame-relay

1 Answers  


Regarding frame relay, which of the following statements are true? A.) You must use ANSI encapsulation if connecting to non-Cisco equipment B.) You must use IETF encapsulation if connecing to non-Cisco equipment C.) You must use Q.933a encapsulation if connecing to non-Cisco equipment D.) You must use Cisco encapsulation if connecting to non-Cisco equipment

1 Answers  


Mention what command you must use if you want to delete or remove the configuration data that is stored in the nvram?

1 Answers  


What parameter is used with statically assigned routers to tell packets which interface to use to reach a distant network? A.) Mask B.) Subnet C.) Default gateway D.) Interface

1 Answers  


Which of the following is a valid TCP/IP socket for an Email connection? 101.34.2.125:25 00-00-03-1B-CA-6F:143 202.167.23.101:21 60.4:110

2 Answers  


Which protocol comes under hybrid dynamic type?

1 Answers  


Novell NetWare has an Ethernet frame type called Ethernet_SNAP. What is the matching Cisco command line keyword for this encapsulation method? A.) arpa B.) sap C.) snap D.) gns E.) dix F.) novell-ether

1 Answers  


Categories