Answer / guest

Answer:: A & B

What does the IPX maximum-path command do? A.) Allows you to disable the TTL on an IPX packet B.) This parameter is only used in NLSP routing C.) Sets the maximum metric that can appear in the routing table D.) Configures round robin load sharing over multiple equal metric paths (parallel paths)

1 Answers  

---

Which commands will restart the router? A.) router#system exit B.) router >reload C.) router#shutdown D.) router#reload E.) router#(config)reload F.) router#system restart

10 Answers  

---

2500 Value in which type of access list?

0 Answers  

---

Can you describe the Authentication Header (AH) Protocol?

0 Answers   CCIE,

---

What would be the proper wildcard mask to permit all odd numbered hosts on the 10.48.0.0/12 network? access-list 1 permit 10.48.0.0 0.15.255.255 access-list 1 permit 10.48.0.1 0.15.255.254 access-list 1 permit 10.48.0.0 0.15.255.1 access-list 1 permit 10.48.0.0 0.0.0.254 access-list 1 permit 10.48.0.0 0.0.0.255

5 Answers  

---

What does the following series of commands accomplish? router igrp 71 network 10.0.0.0 router igrp 109 network 172.68.7.0 A. It isolates networks 10.0.0.0 and 172.68.7.0. B. It loads igrp for networks 109 and 71. C. It disables RIP. D. It disables all routing protocols.

1 Answers  

---

What is the default IPX Ethernet encapsulation? A.) SNAP B.) Arpa C.) 802.2 D.) Novell-Ether E.) SAP

2 Answers  

---

Explain what is route poisoning?

0 Answers  

---

what is distance vector protocol link state protocol and what is the diffrence between them

6 Answers   HCL, Wipro,

---

what is the high order bit in class a 1 11 110 10 mine answer 1

2 Answers  

---

Explain the types of nat?

0 Answers  

---

What is difference between static and dynamic routing?

0 Answers  

---