How signalling can be explained in D channel of ISDN?

1 Answers   Tulip,

---

Which of the following would not be displayed by the command ?sho cdp neighbor detail?? A.) The incoming/outgoing interface. B.) The hardware platform. C.) One address per protocol. D.) Amount of Flash Memory Available E.) The routers hostname. F.) The subnet mask, if IP is configured.

1 Answers  

---

Mention what are the ranges for the private ips?

0 Answers  

---

The default routing protocol for IPX is IPX RIP. How do you view the routing updates sent and received by the router? A.) debug ipx routing B.) debug ipx routing activity C.) debug rip D.) show ipx routing E.) sh ipx F.) debug ipx rip

4 Answers  

---

When discussing static routes, what is the gateway parameter used for? A.) Determining the dynamic route B.) Defining the subnet C.) Defining the Administrative Distance D.) Determining the next hop

1 Answers  

---

Hi Guys I am facing one problem while configuring PAP over Point to Point links. Configuration scenario is like this. ROUTER 1: (Hostname – R1) R1(config)#username R2 password CCNA2 R1(config)#interface serial 1/1 R1(config-if)ip address 10.0.0.1 255.0.0.0 R1(config-if)#lock rate 64000 R1(config-if)#encapsulation ppp R1(config-if)#ppp authentication pap R1(config-if)#ppp pap sent –username R1 password CCNA1 R1(config-if)#no shutdown ROUTER 2: (Hostname – R2) R2(config)#usename R1 password CCNA1 R2(config)#interface serial 1/1 R2(config-if)#ip address 10.0.0.2 255.0.0.0 R2(config-if)#encapsulation ppp R2(config-if)# ppp authentication pap R2(config-if)# ppp pap sent –username R2 password CCNA2 R2(config-if)#no shutdown Now problem is that, after configure the command “ppp authentication pap” the “Line protocol” status goes down on each router. But when I disable this command using “no ppp authentication pap”, the “Line Protocol” status goes up. What could be the problem, can anyone explain it plzzz….!!! Thanks in Advance…!! Shahin..

6 Answers  

---

What utility can you use to see the path a packet takes through an internetwork? A.) Route B.) SNMP C.) Trace D.) Ping

3 Answers  

---

How can you measure out exactly 4 litres of water from a tap using a 3 litre and a 5 litre bucket?

7 Answers  

---

Identify the hardware component that stores the bootstrap program? A.) ROM B.) NVRAM C.) Booter load D.) RAM E.) Flash

4 Answers   Wipro,

---

We have one router,we r using two routing protocol eigrp 90 net 1.1.1.0/16, ospf 110 net 1.1.1.0/24 on same router, Is it possible?

6 Answers   Wipro,

---

Which of the following is a characteristic of a switch, but not of a router? A.) Switches forward packets based on the IPX or IP address in the frame B.) Switches forward packets based on the IP address in the frame C.) Switches forward packets based on the MAC address in the frame D.) Switches forward packets based only on the IP address in the packet

1 Answers  

---

Which peer authentication method and which ipsec mode is used to connect to the branch locations? (Choose two)

0 Answers  

---