What is the command use to add a banner to a cisco router configuration?
- 1 Answers
- 1254 Views
- I also Faced
- E-Mail Answers
Answer / Alka Mishra
To add a banner to a Cisco router configuration, you can use the 'banner' command followed by the type of banner (login, incoming-terminal, or exec). For example, to add a login banner, enter `banner login` and then create the banner message using the multiline editor.
| Is This Answer Correct ? | 0 Yes | 0 No |
Which layer is responsible for flow control, acknowledgement, and windowing? A.) Transport B.) Network C.) Application D.) Session E.) Physical F.) Data Link
As the system administrator, you enter the following commands at the command prompt: ipx routing access-list 800 permit 2b 4d int e0 ipx network 4d ipx access-group 800 out int e1 ipx network 2b int e2 ipx network 3c What did these command accomplish? A. Traffic from network 4c destined for network 4d will be forwarded out Ethernet0. B. Traffic from network 3c destined for network 4d will be forwarded out Ethernet0. C. Traffic from network 2b destined for network 4d will be forwarded out Ethernet0. D. Traffic from network 4d destined for network 2d will be forwarded out Ethernet0.
What is true about frame-relay DLCI? A.) DLCI represents a single physical circuit B.) DLCI is optional in all frame-relay networks C.) DLCI identifies a logical connection between DTE devices D.) DLCI is used to tag the beginning of a frame with VLAN information
Which of the following are examples of ICMP? A.) Traceroute B.) Web Browsing C.) Ping D.) Telnet E.) Destination Unreachable message from a router F.) Inverse Tunnels
Which command will display the IPX routing table? A.) show routes B.) show routes ipx C.) show routes protocol=ipx D.) show ipx E.) show ipx route
What is the standard ISDN term for a native ISDN modem? A.) ET B.) LE C.) TE2 D.) TE3 E.) TA
What is BGP attribute & How many types of attributes are used by BGP???
5 Answers Hathway, HCL, Infinite Computer Solutions,
As a system administrator, you want to debug igrp but are worried that the "debug IP igrp transaction" command will flood the console. What is the command that you should use? A. debug IP igrp event B. debug IP igrp-events C. debug IP igrp summary D. debug IP igrp events
Why ESP Transport mode is not compatible with NAT????? Though New IP Header in Tunnel mode & Original IP Header in Transport mode are out of Authentication & Encryption.
During encapsulation, in which order is information packaged? A. Data, Packet, Segment, Frame B. Segment, Data, Packet, Frame C. Data, Segment, Packet, Frame D. Packet, Data, Segment, Frame E. Frame, Data, Segment, Packet F. Bread, Peanut Butter, Jelly, Bread
Identify the IPX standard access-list number range? A.) 600 - 699 B.) 1000 - 1099 C.) 1 - 99 D.) 100 - 199 E.) 800 - 899
NetWare IPX addressing uses a network number and a node number. Which statements are true? A. The network address is administratively assigned and can be up to 16 hexadecimal digits long. B. The node address is always administratively assigned. C. The node address is usually the MAC address. D. If the MAC address is used as the node address, then IPX eliminates the use of ARP.
CCNA 
